OPERATION
14. TROUBLE SHOOTING GUIDE
TROUBLE | POSSIBLE CAUSE | POSSIBLE REMEDY | |
|
|
|
|
Excessive Vibrations | 1. | Check gear box bolts. | Tighten if loose. |
| 2. | Check for loose nuts on | Tighten if loose. |
| bladeholder and blades. |
| |
| 3. | Check for bent output shaft. If | Replace shaft if bent. |
| shaft is bent, oil will normally leak |
| |
| from bottom seal. |
| |
4.Check to see if blades are free swinging.
5.Check for even wear on each blade tip. Were both blades changed at the same time?
6.Blade broken.
7.Blade carrier bent.
8.Blade hub not properly seated on shaft.
9.New blade or bolts matched with worn blade or bolts.
10.Drivelines not phased cor- rectly. Implement & Tractor yokes must be in line.
Free blades so they swing.
Weigh blades. Weight should be within 1 oz. Always replace both blades.
Replace blades, in sets.
Replace carrier.
Remove hub, check tapered spline shaft, clean and replace.
Replace blades or bolts in sets.
Replace driveline.
OPERATION
1. | Low on lubricant. | Fill to level plug. |
Gearbox Overheating |
|
|
2. | Improper type lubricant. | Replace with NLGI 000 lubricant. |
3. | Excessive trash | Remove trash. |
around gear box. |
| |
4. | Bearing or gears set up | Consult your Dealer. |
improperly. |
| |
SR10M/SR15M | Operation Section |
© 2004 Alamo Group Inc.
