Servis-Rhino SR15M, SR10M manual Driveline Length Check, 44R Equal Angle Driveline Adjustment

OPERATION

44R EQUAL ANGLE DRIVELINE ADJUSTMENT

Adjust drawbar length per operating speed of mower. When connecting drive always check driveline yoke phasing. The end yokes on jackshaft and maindrive should all be in line. Adjust height of jackshaft support bearing up or down so that entire drive is in a straight line from tractor to implement.

(540 RPM 1-3/8"-6)

(1000 RPM 1-3/8"-21)

7.1 Driveline Length Check

WARNING! Before operating the Mower, check to make sure the driveline will not bottom out or become disengaged. Bottoming out occurs when the inner shaft penetrates the outer housing until the assembly becomes solid-it can shorten no more. Bottoming out can cause serious damage to the Tractor PTO by pushing the PTO into the Tractor and through the support bearings or downward onto the PTO shaft, breaking it off.

When fitting the mower to the tractor, the telescoping driveline must be inspected to ensure that at its most compressed position, the profiles do not “bottom out”, and when at its farthest extended position, there is sufficient engagement between the profiles to operate safely. At its shortest length, there must be at least a 1” clearance between each profile end and opposite profile universal joint. At its farthest operating extension, a minimum profile engagement of 12” must be maintained for a Constant Velocity (CV) tube type driveline and a minimum engagement of 6” for non-CV solid shaft drivelines.

SR10M/SR15M 10-01 Operation Section 4-15

© 2004 Alamo Group Inc.

OPERATION