INTRODUCTION
INTRODUCTION
Your
It is recommended that all operators of this implement read this manual or be instructed of its contents as to safety, proper operation, and maintenance before beginning operation.
Your Cutter has been assembled for operation with a tractor PTO input speed of either 540 or 1000 RPM. Should you desire to change PTO input speed, contact your local Rhino dealer who will assist you in performing the necessary modifications. This machine is recommended for use with tractors rated 50 HP (37kW) to 100 HP (75kW) for 540 RPM drive and 50 HP (37kW) to 140 HP (104kW) for 1000 RPM drive.
When ordering parts for the Gearboxes and the Drivelines, be sure to specify the serial number. The serial number is located outside of the right Tongue attaching Plate on the center Mainframe section.
Chain Guards are extra equipment. Deflectors, Driveline Integral Shields, and Gearbox Shields are standard equipment and are to be used at all times.
To place the warranty into effect, fill out the warranty card in full, giving all the requested information, and mail promptly. Be sure to give the serial number of this Cutter.
SR15 | Introduction Section |
© 2004 Alamo Group Inc.
