Servis-Rhino SR10M, SR15M manual Driveline Clamp Cone Yoke Operating Instructions

ASSEMBLY

DRIVELINE CLAMP CONE YOKE OPERATING INSTRUCTIONS

Loosen the yoke clamp cone with a 11/16” (17mm) wrench and remove the cone from yoke. Slide yoke onto the shaft and align hole for clamping cone with annular groove of gearbox shaft. Reinstall cone and tighten (75 lb-ft torque). Push and pull the driveline to ensure it is securely attached to the shaft. Regularly check the driveline yoke to ensure a tight connection. To remove the yoke, remove the connecting cone and pull yoke off the shaft. If the cone cannot be easily removed by hand, drive it out from the other side using a hammer and punch.

NOTE: The clamping cone is serviced only as a complete assembly. Do not attempt to disassemble the clamping cone.

Driveline Yoke

11/16" Bolt End

Clamping Cone

ASSEMBLY

EQUAL ANGLE JACKSHAFT DRIVELINE

10

3 5

12

MOUNT IN THIS HOLE FOR 1000

MOUNT IN THIS HOLE FOR 540

4	8,9
	1
	2

11

13

6,7

Attach bearingsupport weldment (ref #1) to torque weldment as shown. Install jackshaft bearing (ref #2) onto jackshaft stub end.

SR10M/SR15M 10-01 Assembly Section 3-12 R 12-06-01

© 2004 Alamo Group Inc.