
OPERATION
OPERATION
|
| TROUBLE SHOOTING |
|
TROUBLE | POSSIBLE CAUSE | POSSIBLE REMEDY | |
|
|
| |
Gearbox Noisy | 1. Rough gears. | Run in or change gears. | |
| 2. | Worn bearing. | Replace bearing. |
|
|
| |
Gearbox Leaking | 1. Damaged oil seal. | Replace seal. | |
| 2. | Bent shaft. | Replace oil seal and shaft. |
| 3. | Shaft rough in oil seal area. | Replace or repair shaft. |
| 4. | Oil seal installed wrong. | Replace seal. |
| 5. | Oil seal not sealing in the | Replace seal or use a sealant on |
| housing. | OD of seal. | |
| 6. | Oil level too high. | Drain oil to proper level. |
| 7. | Sand hole in casting. | Replace castings or gear box. |
| 8. | Gasket damaged. | Replace gasket. |
| 9. | Bolts loose. | Tighten bolts. |
|
|
|
|
Clutch Slips Excessively | 1. | Clutch linings badly worn or | Repair clutch per maintenance |
| plates warped. | section of manuals. | |
| 2. | Too much power for clutch. | Reduce ground speed and |
|
|
| material intake. |
|
|
|
|
| 3. | Oil on facings. | Replace facings. |
| 4. | Friction facings glazed. | Clean with emery cloth. |
Blade Wears Too Fast | 1. | Cutting in sandy conditions. | Increase cutting height. |
| 2. | Cutting in rocky conditions. | Increase cutting height. |
| 3. | Soft "will fit" blades. | Use genuine Rhino HT blades. |
|
|
| |
Hydraulic Cylinder Will Not | 1. Not enough pressure. | Check pressure. | |
Operate | 2. | Valve not connected properly. | |
| |||
| 3. | Quick coupler not completely | Complete connection. |
| connected. |
|
SR10M/SR15M | Operation Section |
© 2004 Alamo Group Inc.