Heat Controller, Inc. | INSTALLATION MANUAL | VMH InverterFlex |
4. Indoor unit installation
1.Pass the piping through the hole in the wall.
2.Put the upper claw at the back of the indoor unit on the upper hook of the installation plate, move the indoor unit from side to side to see that it is securely fastened (see
Fig.12).
3.Separate the bottom of the indoor unit from the wall by inserting spacer, etc., between the indoor unit and the wall. Remove spacer after piping is complete.
4.Push the lower part of the indoor unit up on the wall, then move the indoor unit from side to side, up and down to check if it is secure.
Spacer
8