Heat Controller, Inc. |
| User Manual |
|
|
|
The
Menu Navigation Shortcuts
1.From any other screen than the home screen, hold down the left arrow button ( 
) to return to the home screen.
2.From the home screen, hold the left arrow button ( 
) to go to the System Status screen.
1.0 Operating Mode Selection
To set the Operating Mode of your thermostat, navigate to the MODE user option on the Home Screen using the left/right arrow buttons and press the center button. The Operating Mode Menu shows the possible Operating Modes with the currently active Operating Mode highlighted. Use the up/ down arrow buttons to select the desired Mode for use and press the center button to save your selection. The following Modes are available:
•Off (default): No equipment operation
•Auto: Thermostat automatically controls the equipment to run either heating or cooling depending on the setpoints.
•Cool: Thermostat controls cooling equipment depending on Cooling setpoint
•Heat: Thermostat controls heating equipment depending on Heating setpoint
•Emergency Heat: Thermostat controls auxiliary heat. No compressor operation.
SYSTEM STATUS
LT1 TEMP |
| 38.1 |
LT2 TEMP |
| 79.9 |
COMP DISCHARGE | 157.7 | |
HOT WATER EWT | 121.5 | |
LEAVING AIR |
| 75.1 |
LEAVING WATER | 73.3 | |
ENTERING WATER | 78.5 | |
ECM BLOWER RPM | 550 | |
ECM TARGET CFM | 800 | |
ECM BLWR STATIC | 0.5 | |
PUMP WATTS |
| 140 |
FLOW RATE GPM | 7.4 | |
PUMP SPEED |
| 60% |
PREVIOUS |
|
|
10/13/11 | 8:27 AM | |
| FAN AUTO | |
RH 41% | HUMID ON | |
69° | AUTO | |
| SETPOINT | |
| HEAT 62 | |
| COOL 82 | |
RH TEMP MODE FAN MENU OPERATING MODE MENU
OFF
AUTO
COOL
HEAT
EMERGENCY HEAT
CHANGE MODE
PREVIOUS SAVE
3