Heat Controller Comfort Air Important Grounding Requirements, Installation

Page 2

INSTALLATION

ELECTRICAL REQUIREMENTS & SAFETY PRECAUTIONS

Power Cord with

Arc Detection Device

The power cord supplied with this air condi- tioner is equipped with an Arc Detection Device designed to shut off power to the unit when it senses an arc fault condition. An arc fault is an unintentional electrical discharge that occurs when electrical products or wires are damaged, aged, or improperly used. An arc fault can be potentially hazardous if left undetected.

WARNING

•Do not remove or modify this plug

•Do not use as an on/off switch

•Do not use outdoors

•Do not push furniture against or place furniture on the electrical cord. This can trip the test switch and/or damage the cord and become a potential condition for arcing

•Do not attempt to repair the cord. If the cord requires replacement, call an authorized servicer.

•The Arc Detection Device is not a Ground Fault Interrupter and should not be used as such

•The Arc Detection Device contains an electronic circuit board and should not be submerged or exposed to water spray

Resetting

If the Arc Detection Device has tripped, the reset button will pop up.

Follow these steps to reset the Arc Detection Device:

1.Unplug unit from electrical outlet

2.Press the reset button

3.Plug the unit back into electrical outlet

4.Check to see if power has returned to the unit

Testing

You should test the Arc Detection Device equipped power cord monthly, after every major electrical storm, or if power to your Room Air Conditioner has been interrupted.

Follow these steps to test the Arc Detection Device:

1.Unplug unit from electrical outlet

2.Press the reset button

3.Plug the unit back into electrical outlet

4.Press test button. Unit should trip and reset button will pop up.

5.Press reset button again for use

If above test fails, stop using the air conditioner and contact customer service.

Warning

Electrical Shock Hazard

• Plug unit only into a grounded electrical outlet.

•Do not use an extension cord or plug adapter with this unit.

•Do not operate unit with decorative front or filter removed.

•Failure to follow these precautions could result in electrical shock, fire or personal injury.

•If the air conditioner has a serial plate rating of 115 volts and greater than 7.5 amps, it must have its own fuse or circuit breaker, and no other device or unit should be operated on that fuse or circuit breaker.

•If the air conditioner has a serial plate rating of 230 volts, it must have its own fuse or circuit breaker, and no other device or unit should be operated on that fuse or circuit breaker.

•We recommend that a qualified electrician install unit in accordance with the National Electrical Code and local codes and ordinances.

•Use copper conductors of correct wire gauge and protector size only.

•Do not alter cord or plug end. Do not remove warning label on cord.

Important Grounding Requirements

•Air conditioner has a three-prong grounding plug on the power supply cord, which must be plugged into a properly grounded three-prong wall receptacle for your protection against possible shock hazard. For models up to and including 7.5 amperes, use a grounding type wall receptacle to match the cord plug.

•For models above 7.5 amperes use a single outlet grounding type wall receptacle to match the cord plug.

Warning

Do not operate this air conditioner without proper time delay circuit protection (circuit breaker or fuse). Refer to serial plate for proper power supply requirements.

Recommended Wire Sizes

(As installed per building code) :

PROTECTOR SIZEWIRE GAUGE 15 AMP #14 MINIMUM

20 AMP #12 MINIMUM

30 AMP #10 MINIMUM

125V 250V 250V 250V

15A 20A 15A 30A

Additional Safety Precautions

•Do not cut, alter or remove any of the expanded polystyrene (styrofoam) inside this air conditioner.

•Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.

•Do not introduce objects in the air discharge area. This could cause permanent damage.

•Do not pour liquids on the air conditioner as this could cause a malfunction. With the unit unplugged, use a damp cloth for cleaning the unit.

•Do not use strong solvents to clean the air conditioner.

•Clean the air conditioner filter every two weeks to avoid overheating caused by air obstruction. Do not operate without filter.

•Do not obstruct the air intake area of your air conditioner, as this could cause overheating, thus activating the unit’s security switch and shutting off the unit.

•Do not block air circulation to outside louvers of cabinet.

•Do not block air flow inside with blinds, curtains, or furniture, or outside with shrubs, enclosures, or other buildings.

•Do not run the air conditioner with an outside protective cover in place. This could result in fire or mechanical damage within the air conditioner.

•Depending on the model, your air conditioner may weigh as much as 95 pounds. To insure safe handling, obtain the necessary help to lift and position the unit during installation and removal.

•Handle air conditioner with care. Wear protective gloves whenever lifting or carrying the unit.

•Carefully inspect the location where the air conditioner will be installed. Be sure it will support the weight of the unit over an extended period of time.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Inscrivez les numéros de modèle et de série Write down the model and serial numbersEscriba el número de modelo y de serie Installation Important Grounding RequirementsWindow Requirements Installation in Normal Width WindowTools Needed Unit & Window SizeInstallation in Minimum Width Window Inside ViewTemperature/Timer Hour Controls Power ControlSet Temperature/Timer Display Mode ControlTimer can be set to either turn the unit on or off Timer ControlAir Conditioner Remote Control To turn the unit on using the TimerService Cleaning Air FilterOccurrence Possible Cause Solutions Troubleshooting GuideHeat Controller Inc Wellworth Ave. Jackson, MI 49203 É.-U Proof of Purchase DateInstalacion Riesgo de Choque EléctricoRequerimientos Importantes para la Puesta a Tierra Precauciones de Seguridad AdicionalesTamaño de la ventana y de la unidad Herramientas necesariasRequisitos de la ventana Instale los paneles de llenado En algunos modelosInstalación en una ventana de ancho mínimo Consultar los pasos 1 a 7 de las instrucciones precedentesControles de temperatura/hora del reloj Control de alimentaciónPantalla de configuración de temperatura/reloj Control de modoControl Remoto de Acondicionador de Aire Control de velocidad del ventiladorControl del reloj PRECAUCION´Orientación de la corriente de aire Problema Causa Posible SolucionesLocalización y Solución de Averías Limpieza del filtro de aireJackson, MI 49203 É.-U Heat Controller Inc Wellworth AveAvertissement Risque de choc électriqueCordon électrique avec dispositif de détection darc Caractéristiques des fenêtres Dimensions de l’appareil et de la fenêtreOutils nécessaires Fixation des panneaux de remplissagePose dans une fenêtre de largeur minimum Commande du mode Commande marche/arrêtCommandes de la température et du nombre d’heures Commande de la vitesse de ventilationTemporisation intégrée de trois minutes Commande de la minuterieTélécommande de Climatiseur Orientation de l’air Symptôme Causes possibles SolutionsPRECAUTION´ Nettoyage du filtre à airDépannage ET Garantie Preuve de la date de l’achatPage 23-11-2219N-004

Comfort Air specifications

The Heat Controller Comfort Air is a cutting-edge climate control solution designed to provide optimal comfort in any space, whether residential or commercial. This advanced system incorporates a range of features and technologies that streamline temperature regulation, enhance energy efficiency, and improve indoor air quality.

One of the standout features of the Comfort Air is its programmable thermostat. This user-friendly interface allows homeowners to set specific temperature schedules tailored to their daily routines. As a result, the system can automatically adjust heating or cooling levels, ensuring consistent comfort while minimizing energy consumption. The ability to sync the thermostat with Wi-Fi adds another layer of convenience, allowing users to control their HVAC system remotely through a mobile app.

In terms of technology, the Comfort Air employs variable-speed motors that optimize airflow. This innovative mechanism ensures that the system operates at the most efficient speed necessary to maintain the desired temperature. By eliminating the need for traditional on-and-off cycling, this feature not only enhances comfort, but also extends the lifespan of the unit, ultimately saving on maintenance costs.

The Comfort Air also boasts advanced filtration systems that significantly improve indoor air quality. Equipped with high-efficiency particulate air (HEPA) filters, the system captures airborne particles, allergens, and pollutants, providing cleaner air for occupants. Additionally, the integration of UV light technology further sanitizes the air, neutralizing harmful microorganisms.

Another important characteristic of the Comfort Air is its whisper-quiet operation. Unlike traditional HVAC systems that can be disruptive, this unit operates at noise levels so low that it's hardly noticeable. This makes it particularly suitable for spaces where quietude is essential, such as bedrooms, offices, or libraries.

Energy efficiency is a cornerstone of the Comfort Air design. With a high seasonal energy efficiency ratio (SEER) rating, the system effectively reduces energy usage while maintaining high performance standards. This not only translates to lower utility bills but also contributes to environmental sustainability by decreasing overall energy consumption.

In summary, the Heat Controller Comfort Air combines innovative technologies with user-centric features to deliver unparalleled comfort and efficiency. Its programmable thermostat, variable-speed motors, superior air filtration, quiet operation, and energy efficiency make it a leading choice for those looking to enhance their indoor climate while reducing their ecological footprint. Whether for a home or a business, the Comfort Air stands out as a reliable and sophisticated heating and cooling solution.
Top Page Image Contents