Disassembly
6. Fan
1. | Remove the cabinet. (Refer to section 2) |
| |
2. | Remove the brace and shroud cover. |
| |
| (Refer to section 4) |
| |
3. | Remove the side cover with 2 screws.(See Fig. 23) |
| |
4. | Remove the 5 or 6 screws which fasten the condenser. |
| |
5. | Move the condenser sideways carefully. |
| |
6. | Remove the clamp which secures the fan. |
| |
7. | Remove the fan. (See Fig. 23) | Figure 23 | |
8. | |||
|
procedure, above.
7.Shroud
1.Remove the fan. (Refer to section 6)
2.Remove the 2 screws which fasten the shroud.
3.Remove the shroud. (See Fig. 24)
4.
Electricalparts
8.Motor
1.Remove the cabinet. (Refer to section 2)
2.Remove the cover control and disconnect a wire hous- ing in control box. (Refer to section 3)
3.Remove the blower. (Refer to section 5)
4.Remove the fan. (Refer to section 6)
5.Remove the 4 screws which fasten the motor. (See Fig. 25)
6.Remove the motor.
7.
9.Compressor
1.Remove the cabinet. (Refer to section 2)
2.Discharge the refrigerant system using FreonTM Recovery System.
If there is no valve to attach the recovery system, install one (such as a watco
3.Disconnect the 3 leads from the compressor.
4.After purging the unit completely, unbraze the suction and discharge tubes at the compressor connections.
5.Remove the 3 nuts and the 3 washers which fasten the compressor. (See Fig. 26)
6.Remove the compressor.
7.
Figure 24
Figure 25
Figure 26
Service Manual 16