Instructions to installation
| Heat insulation | |
| material | |
| signal wire | |
Lid for right piping | Drain hose | |
| ||
Lid for under piping | Indoor/outdoor | |
Lid for left piping | ||
electric cable |
Piping
| Indoor/outdoor electric cord and drain hose must |
Fix with adhesive tape | be bound with refrigerant piping by protecting tape |
7. Other direction piping
Cut away, with a nipper, the lid for piping according to the piping direction and then bend the pipe according to the position of wall hole. When bending, be careful not to crash pipes.
Connect beforehand the indoor/outdoor electric cable, and then pull out the connected to the heat insulation of connecting part specially.
Hang surely the unit body onto the upper notches of the mounting plate. Move the body from side to verify its secure fixing.
In order to fix the body onto the mounting plate, hold up the body aslant from the underside and then put it down perpendicularly.
The distance between the signal wires and the power cabes should be at least 50mm.
Indoor unit D
C1 | C2 |
Indoor unit C | Indoor unit B | Indoor unit A |
C1 | C2 |
L N | C1,C2 |
To the outdoor unit
Communication cable (Shield wire):
Connecting cable :
Please refer to the indoor unit installation manual to find detailly how to set and check the communication address.
27