Haier AD42NAMBEA(ECO) Care and Maintenance, Points to observe, Cleaning, Post-SeasonCare

Page 10
 Care and Maintenance

Points to observe Care and Maintenance

Points to observe

Turn off the power supply switch.

ON

OFF

Do not touch with wet hand.

Do not use hot water or volatileliquid.

Do not

Thinner CleaningCare and Cleaning of the unit use!

Post-Season CarePre-Season Care Benzine

Manual background Tooth powder

Manual backgroundManual backgroundCAUTION

Do not open the inlet grill until fan stops completely.

Fan will continue rotating for a while by the law of inertia after operation is being stopped.

Cleaning

Manual backgroundCAUTION

Do not dry the air filter with fire.

Do not run the air conditioner without the air filter.

Care and Cleaning of the unit

Clean with soft and dry cloth.

Manual background If it is very dirty, dissolve neutral detergent in the lukewarm water and make the cloth wet with the water. After wiping, clean off the detergent using clean water.

Post-Season Care

Manual background Operate the unit with FAN mode on a fair day for about half a day to dry the inside of the unit well.

Manual background Stop operation and turn off the power supply switch. Electric power is consumed even the air conditioner is in stop. Manual background Clean the air filter and set it in the place.

Pre-Season Care

See that there are no obstacles blocking the air inlet and air outlet of both indoor and outdoor units.

Manual background Make sure that the air filter is not dirty.

Manual background Cut in the power supply switch 12 hours before starting run.

9

Image 10
Contents AD182AMBEAECO AD242AMBEAECO AD28NAMBEAECO DUCT TYPE AIR CONDITIONERAD36NAMBEAECO AD42NAMBEAECO Table of Contents Safety Instructions and Warnings CautionsDisposal of the old air conditioner CAUTIONS FOR INSTALLATION Safety PrecautionsCAUTIONS FOR OPERATION Safety Precautions CAUTIONS FOR TRANSFER OR REPAIRSafety Precautions The machine is adaptive in following situationAD182AMBEAECO AD242AMBEAECO AD28NAMBEAECO Parts and FunctionsAD36NAMBEAECO AD42NAMBEAECO Cooling or heating is not sufficient MalfunctionUnit fails to start Cooling is not sufficientMalfunction The followings are not malfunctionCare and Cleaning of the unit Care and MaintenanceCleaning Points to observeWhen heating is started For Preparation of HeatingHot KeepWARMING OPERATION When the room thermostat is actuatedFor inspection and maintenance Is The Unit Installed CorrectlyInstallation place Electric workInstallation Manual For Indoor Unit 1. Safety precautionsInstallation Manual For Indoor Unit AD36NAMBEAECO Installation Manual For Indoor Unitb Hanger bolts installation AD42NAMBEAECOAdjusting to the levelness Installation Manual For Indoor Unit5 Installation of indoor unit When the high performance filter is usedABlowout duct Installation Manual For Indoor Unit7 Installation work for air outlet ducts 8 Connection of suction, exhaust ductsInstallation Manual For Indoor Unit 5. Electric wiring2.5mm2 HAIER GROUP