Haier AD242AMBEA(ECO) Malfunction, Unit fails to start, Cooling or heating is not sufficient

Page 8
 Malfunction

Unit fails to start Malfunction

please check the following things about your air conditioner before making a servie call.

Unit fails to start

Is the power source switch adjust cut in?

ON

OFF

Power supply switch is not ON.

Is city supply power in

Isn't the signal receiving

normal?

section exposed to the

 

direct sunlight or strong

 

illumination?

Power

 

stoppage?

 

Isn't the earth leakage breaker in action?

It is dangerous. Turn off the power supply switch immediately and contact the sales dealer.

Cooling or heating is not sufficient

Is the thermostat adjust Isn't the air filter dirty? as required?

Isn't any doors or windows left open?

Doesn't any obstacle exist at the air inlet or outlet?

Isn't the swing louver

Cooling is not sufficient

 

horizontal?

 

 

 

Isn't sun-shine invading

Isn't any unexpected

Isn't the room much

(At HEATING mode)

If swing louver is horizontal,

direct?

heating load generated?

crowded?

the blow wind does not reach

 

 

 

floor.

 

 

 

The wind does not blow

 

 

 

 

 

 

during heating operation

 

 

 

Isn't it warming up?

 

 

 

When the air conditioner does not operate properly after you have checked the above mentioned items or when the following phenomenon is observed, stop the operation of the air conditioner and contact your sales dealer.

The fuse or breaker often shuts down.

Water drops off during cooling operation.

There is a irregularity in operation or abnormal sound is audible.

7

Image 8
Contents AD36NAMBEAECO AD42NAMBEAECO DUCT TYPE AIR CONDITIONERAD182AMBEAECO AD242AMBEAECO AD28NAMBEAECO Table of Contents Disposal of the old air conditioner CautionsSafety Instructions and Warnings CAUTIONS FOR OPERATION Safety PrecautionsCAUTIONS FOR INSTALLATION Safety Precautions CAUTIONS FOR TRANSFER OR REPAIRSafety Precautions The machine is adaptive in following situationAD36NAMBEAECO AD42NAMBEAECO Parts and FunctionsAD182AMBEAECO AD242AMBEAECO AD28NAMBEAECO Malfunction Unit fails to startCooling or heating is not sufficient Cooling is not sufficientMalfunction The followings are not malfunctionCare and Maintenance CleaningCare and Cleaning of the unit Points to observeFor Preparation of HeatingHot Keep WARMING OPERATIONWhen heating is started When the room thermostat is actuatedIs The Unit Installed Correctly Installation placeFor inspection and maintenance Electric workInstallation Manual For Indoor Unit 1. Safety precautionsInstallation Manual For Indoor Unit Installation Manual For Indoor Unit b Hanger bolts installationAD36NAMBEAECO AD42NAMBEAECOInstallation Manual For Indoor Unit 5 Installation of indoor unitAdjusting to the levelness When the high performance filter is usedInstallation Manual For Indoor Unit 7 Installation work for air outlet ductsABlowout duct 8 Connection of suction, exhaust ducts2.5mm2 5. Electric wiringInstallation Manual For Indoor Unit HAIER GROUP