Haier AS072XHERA, AS122XHERA, AS092XHERA When trouble happens, Insufficient cooling or heating

Page 31

When trouble happens

Insufficient cooling or heating

The operation controller adjusted as required

Air filter too dirty ?

Horizontal swing louver upward ? (in HEAT mode)

Any obstacle exists at the air inlet or outlet?

Door or window left opened ?

Insufficient cooling

Any other heat sources in the room?

Sunlight direct into the room ?

Too crowed in the room ?

Cooled air blown out ( when heating)

When the air conditioner does not operate properly after you have checked the above-mentioned items or when following phenomenon is observed,stop the operation of the air conditioner and contact your sales dealer.

1)The fuse or breaker often shuts down.

2)Water drops off during cooling or drying operation. 3)There is an irregularity in operation or abnormal sound that is audible.

29

Image 31
Contents Wall Mouted Type Indoor Units Contents Disposal of the old air conditioner Refrigerating circuit is leak-proof Applicable ambient temperature rangeSafety precautions Dont dismantle the outlet of the outdoor unit Wiring Indoor Unit Front View Parts and FunctionsRemote Controller Clock set OperationAuto Cool DRY FAN Heat Auto1OFF CoolingDry LOW MID High FanAuto Cool DRY FAN Heat HeatingSwing louvers Vertical louvers Horizontal louvers Air flow adjustmentSleep Remote control unitRemote control unit Timer on/off operationRemote controller operation Timer ON-OFF Timer on-off functionAbout Health operation Health & Fresh Air operationPaint Insecticide Operation and Maintenance Followings are not malfuncition Trouble shootingOFF Customer Need-to-know Using DirectionsCustomer Need-to-know Safety precautions Instructions to installationAccessories for installation Preparation for installationChoose the installation place Method for Cutting and Expanding Pipes When the mounting plate is first fixedOther direction piping Indoor unit communication addresses settingInstallation check Installation check and trial operationTrial operation Insufficient cooling When trouble happensCooled air blown out when heating Insufficient cooling or heatingPossible Reasons Failure codeHaier Group