Haier AS122XHERA, AS072XHERA, AS092XHERA installation manual Paint Insecticide

Page 21

Notes for safety

Clean the dust filter periodically:

Blockage of the dust filter would reduce the cooling and heating effect, consume more power, water would be leaked during cooling, and other failures would also occur.

!

Use the fuse of required capacity:

Never use steel wire or copper wire to take place of the fuse.

!

Never connect the earth wire with the gas pipe, water pipe, lightening arrester, or phone line.

Never install the air conditioner where the flammable gas is easily leaked.

Do not spray any paint or insecticide on the air conditioner.

Paint

Insecticide

Never pour water on the indoor unit.

Keep the inlet and outlet of the didoor unit unblocked.

When the louver is being swung, never touch the outlet or put anything into the air grille.

Operate the unit with the remote controller.

!

!The instructions with this warning mark must be carried out strictly,for they are all concerned with safety of the product or human beings.

The instructions with this prohibiting mark must be completely forbidden,otherwise the product would be damaged or the human being would be injured.

19

Image 21
Contents Wall Mouted Type Indoor Units Contents Disposal of the old air conditioner Refrigerating circuit is leak-proof Applicable ambient temperature rangeSafety precautions Dont dismantle the outlet of the outdoor unit Wiring Indoor Unit Front View Parts and FunctionsRemote Controller Clock set OperationAuto Cool DRY FAN Heat Auto1OFF CoolingDry LOW MID High FanAuto Cool DRY FAN Heat HeatingSwing louvers Vertical louvers Horizontal louvers Air flow adjustmentSleep Remote control unitRemote control unit Timer on/off operationRemote controller operation Timer ON-OFF Timer on-off functionAbout Health operation Health & Fresh Air operationPaint Insecticide Operation and Maintenance Followings are not malfuncition Trouble shootingOFF Using Directions Customer Need-to-knowCustomer Need-to-know Safety precautions Instructions to installationPreparation for installation Accessories for installationChoose the installation place Method for Cutting and Expanding Pipes When the mounting plate is first fixedOther direction piping Indoor unit communication addresses settingInstallation check and trial operation Installation checkTrial operation Cooled air blown out when heating When trouble happensInsufficient cooling or heating Insufficient coolingPossible Reasons Failure codeHaier Group