Haier AS092XHERA, AS122XHERA, AS072XHERA installation manual Auto Cool DRY FAN Heat

Page 11

Operation

Auto

A

 

TEMP

 

 

 

ON

1

3

HEALTH

OFF

FAN

 

5

 

4

MODE

HEALTH AIRFLOW

 

SLEEP FRESH SWING

CLOCKSET

TIMERSTERILIZE

RESET CODE LIGHT LOCK

1Press ON/OFF button Unit starts running.

The previous status appears on the display (except. TIMER, SLEEP mode)

2Press MODE button. For each press, operation mode changes as follows:

Remote

AUTO COOL DRY FAN HEAT

controller

Select Auto run,

" " appears and auto run starts.

3Select temp. button Press TEMP button

Every time the button is pressed, temp. setting increases 1C

Every time the button is pressed, temp. setting decreases 1 C

If the button is kept pressed, setting will increase or decrease quickly.

4Press FAN,For each press, operation mode changes as follows:

Remote

LOW MID HIGH AUTO

controller

Unit runs at the speed displayed on LCD.

When fan speed is AUTO,it is changed automatically according to the indoor temperature.

5 Press ON/OFF button Unit stops running.

Note:

During Auto run operation, temp. setting will be shown in LCD display, unit will select heating, cooling or fan operation according to the room temp.

9

Image 11
Contents Wall Mouted Type Indoor Units Contents Disposal of the old air conditioner Refrigerating circuit is leak-proof Applicable ambient temperature rangeSafety precautions Dont dismantle the outlet of the outdoor unit Wiring Indoor Unit Front View Parts and FunctionsRemote Controller Clock set OperationAuto Cool DRY FAN Heat Auto1OFF CoolingDry LOW MID High FanAuto Cool DRY FAN Heat HeatingSwing louvers Vertical louvers Horizontal louvers Air flow adjustmentSleep Remote control unitRemote control unit Timer on/off operationRemote controller operation Timer ON-OFF Timer on-off functionAbout Health operation Health & Fresh Air operationPaint Insecticide Operation and Maintenance Followings are not malfuncition Trouble shootingOFF Customer Need-to-know Using DirectionsCustomer Need-to-know Safety precautions Instructions to installationChoose the installation place Preparation for installationAccessories for installation Method for Cutting and Expanding Pipes When the mounting plate is first fixedOther direction piping Indoor unit communication addresses settingTrial operation Installation check and trial operationInstallation check Insufficient cooling When trouble happensCooled air blown out when heating Insufficient cooling or heatingPossible Reasons Failure codeHaier Group