JVC RC-EX30B manual Troubleshooting, Symptom Possible cause Action

Page 25

TROUBLESHOOTING

• If you are having a problem with your unit, check this

• If you cannot solve the problem from the hints given

list for a possible solution before calling for service.

here, or the unit has been physically damaged, call a

 

 

 

qualified person, such as your dealer, for service.

 

 

 

 

 

Symptom

 

Possible cause

Action

 

 

 

 

 

Power cannot be turned on.

 

The power cord is unplugged.

Connect the power cord.

 

 

 

 

 

 

When PLAY 2 is pressed, tape does not

 

PAUSE 8 is pressed.

 

 

Press PAUSE 8 again to release it.

move.

 

 

 

 

 

 

 

 

 

 

Playback sound is at a very low level.

 

• Batteries are run down.

• Replace the batteries with new ones.

 

 

• The head is dirty.

 

 

• Clean the head.

 

 

 

 

 

REC ¶ does not function.

 

• The safety tabs of the cassette have

• Reseal the slots with adhesive tape.

 

 

been broken off.

 

 

 

 

 

• No cassette is loaded.

• Load a cassette.

 

 

 

 

 

 

English

The disc is loaded but does not play.

 

• The disc is upside down.

 

 

• The disc is dirty.

 

 

• The disc is damaged or warped.

 

 

• The lens is dirty.

 

 

• There is moisture condensation.

 

 

 

No sound from the speakers.

 

Headphones are conneced.

 

 

 

Since the tape speed is irregular, wow

 

• The pinch roller or capstan is dirty.

and flutter occur.

 

• Batteries are run down.

 

 

 

Radio reception is poor and there is

 

The antenna is not properly adjusted.

much static.

 

 

 

 

 

Load the disc with the label side facing up.

Clean the disc.

Replace the disc with a playable one.

Clean the lens.

Turn the unit on and wait one or two hours before use.

Disconnect the headphones.

Clean the pinch roller and capstan.

Replace the batteries with new ones.

Adjust the antenna correctly.

Remote control is impossible.

 

• Batteries in the remote control unit are

• Replace the batteries with new ones.

 

 

run down.

 

 

 

• The remote sensor section is exposed

• Try not to operate the unit under direct

 

 

to bright light (direct sunlight, etc.)

sunlight, etc.

 

 

 

 

 

Note:

When the unit is moved from a cold place of around 0˚C (32˚F) to a warm place, it may not operate normally, because moisture has formed inside the deck. Normal operation will be restored after waiting one or two hours.

22

Image 25
Contents RC-EX30B For U.S.A Avisos, precauciones y otras notasImportant for Laser Products Features ContentsSafety Precautions Avoid using the unit in the following places Handling PrecautionsOperation on household AC Power SupplyOperation on batteries Top and front sides Names of Parts and ControlsInstalling batteries Remote Control UnitBattery replacement Replace the battery coverTurning the Unit ON/OFF To switch off the power supply completelyNames of buttons STANDBY/ON buttonTo show the clock when the unit is on Setting the ClockAdjusting the volume Adjusting the SoundListening through headphones Selecting the sound modeCleaning discs When playing a CD-R or CD-RWPlaying Compact Discs Handling discsBasic operation Adjust the volume and soundTo stop playback Press PLAY/PAUSE 3/8 to start playbackSkipping To pause playbackSelecting a desired track directly Selecting a desired group album and track MP3 disc onlyRepeat/Random playback Press Repeat on the remote control unit during playbackRepeat playback Random playbackProgrammed playback Playing back introductions Intro playback Programmed playback of an MP3 discUsing the antennas Changing the FM reception modeTuning in a preset station Presetting stationsPress Preset UP or Preset Down to select the preset number Loading a cassette Cassette PlaybackClose the cassette holder by pressing it gently and firmly Press Play 2 to start playback Adjust the volume and sound Press Tape to enter the tape mode Load a cassetteFast-winding a tape Press STOP/EJECT §Recording Using the beat-cut functionStandard recording To stop recordingPress Tape on the unit to enter the tape mode Press REC ¶ Load a CD Press CD/RANDOM to enter CD modeSynchronized recording with CD playback ErasingCleaning the heads, capstan and pinch roller MaintenanceCleaning the CD pickup lens Open the disc door and clean the lensSymptom Possible cause Action TroubleshootingCD player SpecificationsTuner Cassette deckWarranty Repair / Replacement Form Limited Warranty Victor Company of Japan, Limited Chaine Portable a CD Mises en garde, précautions et indications diverses For Canada/pour le Canada Cm CD playback capability Handling Precautions Power Supply Names of Parts and Controls Output is switched off with headphones connected Turning the Unit ON/OFF Setting the Clock Adjusting the Sound Playing Compact Discs Cm CD can be played on the unit without an adapter To pause playback Repeat/Random playback Programmed playback Programmed playback of an MP3 disc Radio Reception Presetting stations Cassette Playback Basic operation Recording Synchronized recording with CD playback Maintenance To bright light direct sunlight, etc Sunlight, etc DC 9 V R20 SUM-1/D EN, FR