JVC UX-J50, UXJ60 manual Connecting Speakers, To connect an outdoor AM MW antenna, For UX-J60

Page 10

AM (MW) antenna

1	2

Connecting Speakers

FOR UX-J60:

1

ANTENNA

EXT

LOOP

75 FM COAXIAL

3

Vinyl-covered wire

(not supplied)

2			3
Grey	RIGHT	LEFT RIGHT	LEFT	Red
				Red
Speaker

AM loop antenna

(supplied)

1If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.

2Connect the AM loop antenna to the AM LOOP terminals as illustrated.

3Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM (MW) antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. The AM loop antenna must remain connected.

For better reception of both FM and AM (MW)

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

cord	MAIN SPEAKERS	SUBWOOFERS	Speaker
	CAUTION: SPEAKER IMPEDANCE 6 -16		cord
	Blue	Black
INPUT	INPUT	INPUT	INPUT
Right speaker		Left speaker
FOR UX-J50:
	SPEAKERS RIGHT	LEFT
Speaker cord
	SPEAKER		Speaker cord
	IMPEDANCE
	6 - 16
Right speaker		Left speaker

7

Image 10

Contents Instructions Important for Laser Products Above ALL Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlFront Panel For UX-J50Display Window Pressing this button also turns on the unitRemote Control 10+10Getting Started Supplied AccessoriesConnecting Antennas FM antenna To connect an outdoor FM antennaTo connect an outdoor AM MW antenna Connecting SpeakersAM MW antenna For UX-J60To remove the speaker grilles Connecting Other EquipmentRelease your finger from the clamp To connect an audio equipmentPress CLOCK/TIMER Setting the ClockTurning On the Power Press UP or Down to Adjust the hour, thenBass level or press Treble to adjust the treble level Adjusting the VolumePress Bass to adjust Enjoying Sound EffectsTo enjoy the heavy sound only for UX-J60 Selecting the Display Color only for UX-J60Selecting the Illumination Brightness Press Sound TurboTuning in to a Station Presetting StationsPress UP or Down to select a preset number Tuning in to a Preset StationReceiving FM Stations with RDS Press Display orange-colored Changing the RDS InformationSearching for Programs by PTY Codes PTY Search Press PTY SearchData type you want appears on Display Switching Temporarily to a Program Type of Your ChoicePress TA/NEWS/INFO until Wait for about 3 seconds after specifying the data typePress CD Playing Back DiscsPlaying Back the Entire Disc-Normal Play Press CD 3/8Basic Disc Operations Program PlayProhibiting Disc Ejection-Tray Lock Playing at Random-Random PlayRepeating Tracks-Repeat Play Press RandomPlaying Back Tapes To play both sides-Reverse ModePress REV.MODE reverse mode Playing Back a TapeRecording on a Tape To record on both sides-Reverse ModeRecording Press REC recordingDisc Direct Recording Press REV.MODE reverse mode repeatedly Until or is litTo stop while recording, press Set the on-time when you want the unit to turn on Using the TimersUsing Daily Timer and Recording Timer Set the off-time when you want the unit to turn off standbyPress STANDBY/ON to turn Using Sleep TimerAdjust the clock if you need Press SleepMaintenance TroubleshootingDescription of the PTY codes Alarm functionAdditional Information Test functionSpecifications Memo Memo 0103MWMMDWJEM