JVC UX-J50, UXJ60 manual Introduction, About This Manual, Precautions

Page 4

Introduction

We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference.

About This Manual

This manual is organized as follows:

The manual mainly explains operations using the buttons on the remote control.

You can use the buttons both on the remote control and on the main unit for the same operations if they have the same or similar names (or marks), unless mentioned otherwise.

The illustrations used in this manual are of UX-J60 unless mentioned otherwise.

Basic and common information that is the same for many functions is grouped in one place, and is not repeated for each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Common Operations” on pages 9 to 11.

The following symbols are used in this manual:

Gives you warning and caution to prevent damage or risk of fire/electric shock. Furthermore, it gives you information about what is not good for obtaining the best possible performance from the unit.

Gives you information and hints you should know.

Power sources

When unplugging the unit from the wall outlet, always pull on the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

After starting heating in the room

In a damp room

If the unit is brought directly from a cold to a warm place Should condensation occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again.

Others

Should any metallic object or liquid fall into the unit, unplug the power cord and consult your dealer before operating any further.

If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

Precautions

Installation

Install in a place which is level, dry and neither too hot nor too cold—between 5˚C and 35˚C.

Install the unit in a location with adequate ventilation to prevent internal heat buildup in the unit.

Leave sufficient distance between the unit and the TV.

Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

If anything goes wrong, unplug the AC power cord and consult your dealer.

1

Image 4
Contents Instructions Important for Laser Products Above ALL Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Control Front PanelFront Panel For UX-J50Display Window Pressing this button also turns on the unitRemote Control 10+10Supplied Accessories Connecting Antennas FM antennaGetting Started To connect an outdoor FM antennaConnecting Speakers AM MW antennaTo connect an outdoor AM MW antenna For UX-J60Connecting Other Equipment Release your finger from the clampTo remove the speaker grilles To connect an audio equipmentSetting the Clock Turning On the PowerPress CLOCK/TIMER Press UP or Down to Adjust the hour, thenAdjusting the Volume Press Bass to adjustBass level or press Treble to adjust the treble level Enjoying Sound EffectsSelecting the Display Color only for UX-J60 Selecting the Illumination BrightnessTo enjoy the heavy sound only for UX-J60 Press Sound TurboTuning in to a Station Presetting StationsPress UP or Down to select a preset number Tuning in to a Preset StationReceiving FM Stations with RDS Changing the RDS Information Searching for Programs by PTY Codes PTY SearchPress Display orange-colored Press PTY SearchSwitching Temporarily to a Program Type of Your Choice Press TA/NEWS/INFO untilData type you want appears on Display Wait for about 3 seconds after specifying the data typePlaying Back Discs Playing Back the Entire Disc-Normal PlayPress CD Press CD 3/8Basic Disc Operations Program PlayPlaying at Random-Random Play Repeating Tracks-Repeat PlayProhibiting Disc Ejection-Tray Lock Press RandomTo play both sides-Reverse Mode Press REV.MODE reverse modePlaying Back Tapes Playing Back a TapeTo record on both sides-Reverse Mode RecordingRecording on a Tape Press REC recordingDisc Direct Recording Press REV.MODE reverse mode repeatedly Until or is litTo stop while recording, press Using the Timers Using Daily Timer and Recording TimerSet the on-time when you want the unit to turn on Set the off-time when you want the unit to turn off standbyUsing Sleep Timer Adjust the clock if you needPress STANDBY/ON to turn Press SleepMaintenance TroubleshootingAlarm function Additional InformationDescription of the PTY codes Test functionSpecifications Memo Memo 0103MWMMDWJEM