JVC UXJ60, UX-J50 manual Adjusting the Volume, Enjoying Sound Effects, Press Bass to adjust

Continued

Adjusting the Volume

You can adjust the volume level only while the unit is turned on. The volume level can be adjusted between “VOL MIN” and “VOLUME 1” – “VOLUME 40 (VOL MAX).”

On the remote control:

Press VOLUME + to increase the volume or press VOLUME – to decrease it.

To reinforce the bass sound

You can reinforce the bass sound to maintain rich, full bass at low volume—Active Hyper Bass Pro.

For UX-J60:
Press AHB PRO.	AHB
	PRO

• Each time you press the button, the Active Hyper Bass Pro is turned on (AHB ON) and off (AHB OFF) alternately. When it is turned

On the unit:

VOLUME

on, the AHB indicator lights up on the display.

Turn VOLUME + / – control clockwise

(+)to increase the volume or counterclockwise (–) to decrease it.

For private listening

Connect headphones to the PHONES jack.

No sound comes out of the speakers. Be sure to turn down the volume before connecting or putting on headphones.

DO NOT turn the unit off (standby) with the volume set to an extremely high level; otherwise, the sudden blast of sound can damage your hearing, speakers and/or headphones when you turn on the unit or start playing any source next time. REMEMBER you cannot adjust the volume level while the unit is on standby.

Enjoying Sound Effects

You can adjust the sound by using various sound effect functions.

•These functions only affect the playback sound, and do not affect your recording.

To adjust the tone (Bass/Treble)

You can adjust the bass level (low frequency range) and the treble level (high frequency range) within a range of –5 to +5. When shipped, the bass level set to “BASS +2” and the treble level set to “TREBLE +2.”

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start over from step 1.

•For UX-J50 only, you can also use BASS and TREBLE on the unit for this operation.

1 Press BASS to adjust the BASS TREBLE

bass level or press TREBLE to adjust the treble level.

•Each timer you press the button,

“BASS” and “TREBLE” appears in the display alternately.

UP

2 Press UP to increase the level or press DOWN to decrease it.

DOWN

AHB

For UX-J50:
Press AHB PRO until “AHB 1” or “AHB 2”	AHB
appears on the display.	PRO

The AHB indicator also lights up on the display.

•Each time you press the button, the bass reinforcement changes as follows:

AHB 1 AHB 2 AHB OFF (Canceled)

•“AHB 2” has much more bass reinforcement effect than “AHB 1.”

To cancel the effect, press AHB PRO until “AHB OFF” appears on the display and the AHB indicator goes off.

10