Bosch Appliances LBC 325X installation manual Intellivox connector block

Intellivox DDC Installation Manual Installation Guide EN 9

Fig 3 Intellivox connector block.

•A removable panel on the front side of the Intellivox (backside for the Intellivox-1b) allows all connectors to be inserted when the unit is already mounted.

Proceed as follows to fit a WAGO 231 connector:

1.Prepare the cable, about 8 - 9 mm (around 0.35”) of the individual wire insulation should be removed.

2.If required insert the appropriate PVC insert for small wire sizes (refer to Table 2 on the next page). In this way the wire is centered and the insert prevents the insulation from entering the clamp contact.

3.A small screwdriver with blade width around

2.5 mm (0.1”) or a specific wire insertion tool as shown in Fig 5 (right side) might be used to open the clamp contact.

4.In case the screwdriver is used: insert it into the square hole of the corresponding connector pin as shown in the left side of Fig 5. The blade of the screwdriver should be inserted far enough into the connector. The metal spring of the cage clamp, which is visible from the side of the connector,

should be completely covered by the blade of the screwdriver (refer to Fig 4 which shows the internal clamp construction).

5.Push the screwdriver to open the cage clamp, this may require some force. If no PVC insert is placed, the opening of the clamp is visible in the round hole (cable insert) at the top of the connector.

6.Insert the stripped wire into the open cage clamp located inside the round hole.

7.Remove the screwdriver from the connector, the clamp closes and the force exerted on the wire automatically adapts to the wire size.

8.Proceed with step 2 until all wires are connected.

Bosch Security Systems July 2003