Turbosound NuQ SERIES user manual From Mixer LMS-D24

Page 24

user manual

NuQ series

System 2 – Stereo Passive setup with Bass Units and Active Crossover

FROM MIXER

LR

EQ

LMS-D24

MID/HI

LEFT

BASS

POWER AMPLIFIERS

MID/HI

RIGHT

BASS

In this case an LMS-D24 is used to separate the bass and mid / high frequencies and feed them to the appropriate cabinets.

This system can be scaled up with the addition of further amplifiers and processors.

By substituting an LMS-D26 processor for the LMS-D24 there will be two extra channels available for adding perhaps another pair of mid/top cabinets through an extra stereo power amplifier.

The B15 bass speakers shown are rated at 8 ohms impedance so it is possible to run two cabinets from one amplifier, providing the amplifier is powerful enough, although additional amplifiers will still provide the best performance.

It is recommended to use a bass cabinet and a mid/top with each stereo amplifier as this helps distribute the load across the power supplies better.

NB: The EQ shown is for tuning the system to the room / venue.

NuQ manual page 24

Image 24

Contents NuQ Series NuQ series NuQ series Introduction ThanksUnpacking General Features Product Range SummaryGeneral Features for Two-Way Enclosures Model Information NuQ-8NuQ-10 NuQ-12 NuQ-15B15 B18NuQ-8DP NuQ-10DPNuQ-12DP NuQ-15DPB15DP System Requirements Recommended Amplifier Power Ratings Amplifier ConsiderationsSelf-powered Loudspeakers Loudspeaker connections Passive systemsBi-amped systems Cable Recommendations Networking Capability Computer system requirementsHardware requirements TurboDrive Quick Reference Setup Install the driversBvnet Interface Loudspeaker Placement Choosing the best locationDispersion Equalisation System Configurations System1 Basic Stereo Passive setupFrom Mixer LMS-D24 System 3 Stereo Bi-amped setup with Active Crossover From Mixer LMS-D26 Loudspeaker Management Systems Turbosound LMS series loudspeaker management systemsLMS seris Features LMS-D24/6 Quick Reference Set Up About PresetsStarting up Preset Recall Creating a user defined crossoverStore button Audio Input connectors Audio Output connectorsPresets and Secure mode LMS-D24/D26 Audio ConnectionsFlying & Lifting / Rigging Hardware Compatibility Speaker Pole and Tripod Stand MountingUse with Flying Yokes Truss MountingWall Mounting Ceiling Mounting Small Loudspeaker ArraysHorizontal Rigging Using the T-bar Small Vertical ArrayFlying Single Enclosures To create a horizontal array for truss mountingNuQ series Use of Thread Locking Compounds Servicing Information NuQ series NuQ series About Ease Data OverviewUse of Turbosound Ease data Technical Specifications Non-Powered EnclosuresSelf-powered Enclosures B15DP B18DPSpare Parts List NuQ-10/DP NuQ-12/DP NuQ-15/DP B15/DP B18/DPWarranty Limited WarrantyWarranty Coverage ShippingIncidental and consequential damages Limitation of implied warrantiesNuQ series