Turbosound NuQ SERIES Flying Single Enclosures, To create a horizontal array for truss mounting

user manual

NuQ series

To create a horizontal array for truss mounting:

•Assemble the flying yokes and attach them to the cabinets as detailed above using the fixings provided with the flying yokes.

•Swing the yokes around to the tops of the cabinets and attach them to the ends of the T-bar using the fixings provided.

•Attach the SC-01 scaffold clamp to the middle of the T-bar using the screws provided.

NuQ-FY10 Flying Yoke

NuQ-TB Twin Bar

SC-01 Scaffold Clamp

•Lift the assembly on to the truss structure and point the array as required.

Flying Single Enclosures

All NuQ series cabinets, including low frequency enclosures, can be rigged in permanent installations using optional M10 shoulder eyebolts (available from Turbosound or third party suppliers). These can be attached to the rigging points provided on the top and back of the cabinet. The rigging point at the rear of the cabinet is used to alter the downward angle of the enclosure.

As supplied, these rigging points are fitted externally with M10 countersunk slot-head screws. To facilitate rigging of the enclosure simply remove these M10 screws and replace them with M10 x 18mm shoulder eyebolts using a suitable thread locking compound to avoid the possibility of loosening.

Note: Eyebolts must have a thread length of at least 18mm (3/4”).

NuQ manual page 37