Turbosound NuQ SERIES user manual Servicing Information

Page 40

user manual

NuQ series

Servicing Information

If any of the drive units in your NuQ series cabinet should cease functioning and need a replacement re-cone or diaphragm, you are advised to remove the faulty unit from the cabinet and send it to a professional service centre authorised to repair Turbosound loudspeakers.

Removal of the low frequency driver – B15 front loaded bass enclosure

The perforated steel loudspeaker grille (4) is held in place by six M5 button head screws (2), three on each side of the cabinet. Remove these grille retaining screws and set the grille aside for later re-assembly.

Undo the M5 x 35 socket head screws (5) holding the driver (3) in place, remove these together with the flat washers and spring washers, and carefully lift it out and away from the cabinet (1). Make a note of the driver terminal polarity for later reconnection. Disconnect the cables from the drive unit and completely remove the driver from the cabinet being careful not to damage the cone or suspension. Do not place the driver near to any equipment or media that may be adversely affected by strong magnetism, e.g. CRT monitors or magnetic tape of any kind.

To reinstate the speaker simply reverse the above procedure, making sure you observe the correct polarity when reconnecting the cables back into the terminals of the drive units. Tighten the fixing screws.

NuQ manual page 40

Image 40
Contents NuQ Series NuQ series NuQ series Thanks IntroductionUnpacking General Features Product Range SummaryGeneral Features for Two-Way Enclosures NuQ-8 Model InformationNuQ-10 NuQ-12 NuQ-15B15 B18NuQ-8DP NuQ-10DPNuQ-12DP NuQ-15DPB15DP System Requirements Recommended Amplifier Power Ratings Amplifier ConsiderationsSelf-powered Loudspeakers Passive systems Loudspeaker connectionsBi-amped systems Cable Recommendations Computer system requirements Networking CapabilityHardware requirements TurboDrive Quick Reference Setup Install the driversBvnet Interface Choosing the best location Loudspeaker PlacementDispersion Equalisation System Configurations System1 Basic Stereo Passive setupFrom Mixer LMS-D24 System 3 Stereo Bi-amped setup with Active Crossover From Mixer LMS-D26 Loudspeaker Management Systems Turbosound LMS series loudspeaker management systemsLMS seris Features About Presets LMS-D24/6 Quick Reference Set UpStarting up Creating a user defined crossover Preset RecallStore button Audio Input connectors Audio Output connectorsPresets and Secure mode LMS-D24/D26 Audio ConnectionsFlying & Lifting / Rigging Hardware Compatibility Speaker Pole and Tripod Stand MountingUse with Flying Yokes Truss MountingWall Mounting Small Loudspeaker Arrays Ceiling MountingHorizontal Rigging Using the T-bar Small Vertical ArrayFlying Single Enclosures To create a horizontal array for truss mountingNuQ series Use of Thread Locking Compounds Servicing Information NuQ series NuQ series About Ease Data OverviewUse of Turbosound Ease data Technical Specifications Non-Powered EnclosuresSelf-powered Enclosures B15DP B18DPSpare Parts List NuQ-10/DP NuQ-12/DP NuQ-15/DP B15/DP B18/DPWarranty Limited WarrantyWarranty Coverage ShippingIncidental and consequential damages Limitation of implied warrantiesNuQ series