Turbosound NuQ SERIES user manual Preset Recall, Creating a user defined crossover, Store button

Page 30

user manual

NuQ series

Preset Recall

To select a Preset, press the Recall Button so the indicator above it illuminates.

Turn the left of the three parameter knobs (a) until the required Preset number is shown on the display.

NB: Factory presets are indicated by a box symbol appearing after the Preset number.

Press the Recall Button again to activate the Preset. NB: Pressing any other button will cancel the operation.

This process is deliberately in three stages in order to guard against accidental recall of incorrect Presets.

Creating a user defined crossover

In addition to the Factory Presets the unit has two further ‘Base Presets’ for mono and stereo usage. These Base Presets are stored in locations 1 and 2 respectively, they can be used to develop settings for any loudspeaker combination and are recalled in the same way as the Factory Presets described above. These Presets are also locked but the user can name and store their own edited versions in any free preset location.

Store button

To store a preset in a location, press the store button and use the encoders to select the memory location and name the preset. Pressing the store button again completes the task. Pressing any button other than store during the process cancels the procedure.

The store button allows the user to name a preset and choose which memory location it will be held in. Pressing store button again completes the process.

NuQ manual page 30

Image 30
Contents NuQ Series NuQ series NuQ series Introduction ThanksUnpacking General Features Product Range SummaryGeneral Features for Two-Way Enclosures Model Information NuQ-8NuQ-10 NuQ-12 NuQ-15B15 B18NuQ-8DP NuQ-10DPNuQ-12DP NuQ-15DPB15DP System Requirements Recommended Amplifier Power Ratings Amplifier ConsiderationsSelf-powered Loudspeakers Loudspeaker connections Passive systemsBi-amped systems Cable Recommendations Networking Capability Computer system requirementsHardware requirements TurboDrive Quick Reference Setup Install the driversBvnet Interface Loudspeaker Placement Choosing the best locationDispersion Equalisation System Configurations System1 Basic Stereo Passive setupFrom Mixer LMS-D24 System 3 Stereo Bi-amped setup with Active Crossover From Mixer LMS-D26 Loudspeaker Management Systems Turbosound LMS series loudspeaker management systemsLMS seris Features LMS-D24/6 Quick Reference Set Up About PresetsStarting up Preset Recall Creating a user defined crossoverStore button Presets and Secure mode Audio Input connectorsAudio Output connectors LMS-D24/D26 Audio ConnectionsFlying & Lifting / Rigging Use with Flying Yokes Hardware CompatibilitySpeaker Pole and Tripod Stand Mounting Truss MountingWall Mounting Ceiling Mounting Small Loudspeaker ArraysHorizontal Rigging Using the T-bar Small Vertical ArrayFlying Single Enclosures To create a horizontal array for truss mountingNuQ series Use of Thread Locking Compounds Servicing Information NuQ series NuQ series About Ease Data OverviewUse of Turbosound Ease data Technical Specifications Non-Powered EnclosuresSelf-powered Enclosures B15DP B18DPSpare Parts List NuQ-10/DP NuQ-12/DP NuQ-15/DP B15/DP B18/DPWarranty Coverage WarrantyLimited Warranty ShippingIncidental and consequential damages Limitation of implied warrantiesNuQ series