Turbosound NuQ SERIES user manual From Mixer LMS-D26

Page 26

user manual

NuQ series

System 4 – Stereo Bi-amped setup with Sub-bass units and Active Crossover

FROM MIXER

LR

EQ

LMS-D26

HIGH

LEFT

BASS

POWER AMPLIFIERS

HIGH

RIGHT

BASS

POWER AMPLIFIERS

LEFT

SUB-BASS

RIGHT

Note: Bi-amp mode must be selected on the rear panel of the two-way loudspeaker before proceeding with this setup.

The LMS-D26 is used to separate the audio into three frequency bands: high frequency, mid/bass frequency, and sub-bass. As with the previous systems, additional cabinets may be connected dependent on amplifier capability.

NB: The EQ shown is for tuning the system to the room / venue.

NuQ manual page 26

Image 26

Contents NuQ Series NuQ series NuQ series Unpacking IntroductionThanks General Features Product Range SummaryGeneral Features for Two-Way Enclosures NuQ-10 Model InformationNuQ-8 NuQ-12 NuQ-15B15 B18NuQ-8DP NuQ-10DPNuQ-12DP NuQ-15DPB15DP System Requirements Recommended Amplifier Power Ratings Amplifier ConsiderationsSelf-powered Loudspeakers Bi-amped systems Loudspeaker connectionsPassive systems Cable Recommendations Hardware requirements Networking CapabilityComputer system requirements TurboDrive Quick Reference Setup Install the driversBvnet Interface Dispersion Loudspeaker PlacementChoosing the best location Equalisation System Configurations System1 Basic Stereo Passive setupFrom Mixer LMS-D24 System 3 Stereo Bi-amped setup with Active Crossover From Mixer LMS-D26 Loudspeaker Management Systems Turbosound LMS series loudspeaker management systemsLMS seris Features Starting up LMS-D24/6 Quick Reference Set UpAbout Presets Store button Preset RecallCreating a user defined crossover Presets and Secure mode Audio Input connectorsAudio Output connectors LMS-D24/D26 Audio ConnectionsFlying & Lifting / Rigging Use with Flying Yokes Hardware CompatibilitySpeaker Pole and Tripod Stand Mounting Truss MountingWall Mounting Horizontal Rigging Ceiling MountingSmall Loudspeaker Arrays Using the T-bar Small Vertical ArrayFlying Single Enclosures To create a horizontal array for truss mountingNuQ series Use of Thread Locking Compounds Servicing Information NuQ series NuQ series About Ease Data OverviewUse of Turbosound Ease data Technical Specifications Non-Powered EnclosuresSelf-powered Enclosures B15DP B18DPSpare Parts List NuQ-10/DP NuQ-12/DP NuQ-15/DP B15/DP B18/DPWarranty Coverage WarrantyLimited Warranty ShippingIncidental and consequential damages Limitation of implied warrantiesNuQ series