Turbosound TCS SERIES USER user manual Rigging Instructions for a 3-wide TCS-56/59 array

Page 25

user manual

TCS series

Rigging Instructions for a 3-wide TCS-56/59 array

Parts required: 3 x TCS-56 or TCS-59 enclosures

1 x TP-55/3 flying assembly top plate

1 x BP-55/3 flying assembly bottom plate

4 x M10 x 36mm shoulder eyebolts

8 x M10 x 36mm hex head bolts

12 x flat washers

12 x spring washers

1.Set the cabinets out on the floor with the approximate desired horizontal splay angle.

2.Remove the countersunk screws from the rigging points on the top of the cabinets.

3.Set the TP-55/3 flying assembly top plates (two are required per array) on the cabinets, aligning the slots with the enclosure rigging points.

4.Assemble the top plates to the cabinets using M10 x 36mm eyebolts and M10 x 36mm hex head bolts as shown.

5.Set the cabinets to the desired horizontal angle using the marked positions on the top plate. As a starting point this will generally be 0° between cabinets (tight packed) in the case of the TCS-56, and 30° in the case of the TCS-59.

6.Invert the array and attach the BP-55/3 bottom plate to the bottom of the cabinets by removing the countersunk screws and replacing them with M10 x 36mm hex head bolts.

7.Make final adjustments to the angle between cabinets in order to achieve the best coverage from the array. Tighten all hardware and prepare to lift the array into position.

8.Downward inclination of the completed array can be set using the eyebolts attached to the rear rigging points on the two outside TCS- 56/59 cabinets.

9.Attach safety chains to the holes provided at the rear of the flying assembly top plates.

tcs manual page 25

Image 25
Contents TCS Series TCS series TCS series TCS series Unpacking the TCS series loudspeaker ThanksIntroduction FeaturesProduct Range Summary TCS series TCS series Amplifier considerations System RequirementsSystem Configurations TCS series LMS-D6 Loudspeaker Management System Loudspeaker Connections Cable Length Connecting CablesGeneral Flying and LiftingFlying single enclosures TCS series TCS series Installation of a single TCS series enclosure using eyebolts TCS series Flying multiple TCS-56/59 enclosures TCS series Rigging Instructions for a 2-wide TCS-56/59 array Rigging Instructions for a 3-wide TCS-56/59 array Rigging the TCS-40 with 3-wide TCS-56/59 arrays 12 LF, 1 HF TCS-20 TCS-30 TCS-35 TCS-40 TCS-56 TCS-59TCS-108SP Warranty Coverage Limited WarrantyShipping Limitation of implied warranties Incidental and consequential damagesUse of thread locking compounds Appendix CTCS series