Setup
Setup
Tighten Clamps
See FIG. 4. Before starting, torque the screws (3) secur- ing the four clamps (4) to
1 Torque to
Wet Cup Drain Fitting
As supplied, the side port of the wet cup is plugged. To install a drain tube, remove the plug and install the sup- plied 90° tube fitting (R) in its place. Attach a 1/2 in. (13
mm)ID flexible plastic tube (not supplied) to the fitting to drain any overflow to a pail.
3 1
ti14668a
FIG. 4. Wet Cup
Wet Cup
See FIG. 5. Before starting, fill the wet cup (P) 1/3 full with Graco Throat Seal Liquid (TSL) or compatible sol- vent.
NOTE: The wet cup has a covered fill port fitting. A plug
(9)is shipped loose with the pump and can be installed in place of the covered fitting if desired.
Torque Wet Cup
MaxLife pumps use a special
P
R
9
ti14667a
FIG. 5. Wet Cup
12 | 3A0096B |