Goodman Mfg 000 &12, MSC/MSH 9 Refrigerant Piping & Condensate Piping Installation

NOTE: Install the mounting bracket and drill the holes in the wall according to the wall structure and the correspond- ing mounting points on the mounting bracket. (The mounting brackets vary according to the model.)

Correct orientation	Incorrect orientation
of Installation Plate	of Installation Plate

Wall

Indoor

Outdoor

3/16”-1/4” 5-7mm

Figure 4

4.Determine the hole positions according to the diagram

detailed in Figures 5A & 5B. Drill one (1) 2.5” hole (65mm), slanting slightly to the outside.

NOTE: Always use wall hole conduit when drilling metal grid, metal plate, etc.

C D

Model B (A: 31” (790mm), B:10” (265mm), C:4” (100mm), D: 6” (151mm)

Figure 6

Do NOT install drain hose as shown in Figure 7.

Do not block water flow by a rise.	Do not put the end of
	drain hose into water.

Figure 7

6.When connecting extension drain hose, insulate the con- necting part of the extension drain hose with a shield pipe. Do not allow the drain hose to be slack.

7.REFRIGERANT PIPING INSTALLATION:: For the left- hand and right-hand piping, remove the pipe cover from the side panel. (Figure 8.)

	Figure 5A
6” (150mm)	7” (187mm)
	Figure 8
	8. For the rear right-hand and rear left-hand piping, install as
	shown in Figure 9.
	Figure 5B

Refrigerant Piping & Condensate Piping

Installation:

5. Drain hose should be installed with a slight downward slope. (See Figure 6.)

Figure 9

To make refrigerant tube connections, refer to Tightening

Connection in the Refrigerant Piping Connection.

4