Motorola CP200TM, CP150TM manual Turning Off the Radio

Page 42

Turning On the Radio

Turn On/Off/Volume Control knob clockwise. If the radio successfully powers up, you will hear the Self Test Pass tone and see the LED light green. If the radio fails to power up, you will hear the Self Test Fail tone.

Turning Off the Radio

Turn On/Off/Volume Control knob counter- clockwise until you hear a click.

Adjusting the Radio Volume

1.Press and hold Volume Set button (preprogrammed by your dealer) until you hear a continuous tone.

2.Turn On/Off/Volume Control knob to adjust volume level.

3.Release Volume Set button at desired volume level.

Selecting a Radio Channel

Turn Channel Selector knob clockwise or counter- clockwise to reach desired channel.

Receiving

1.Turn on the radio.

2.Adjust the volume level.

3.Select the radio channel.

Transmitting

1.With radio on, turn Channel Selector knob to required channel.

2.Press PTT and speak clearly with mouth about 2.5 to 5 cm (1 to 2 inches) away from microphone.

3.Release PTT when call is completed.

Audio Indicators for Programmable Buttons

Programmable

Positive

Negative

Indicator

Indicator

Buttons

Tone

Tone

 

 

 

 

Scan

Start Scan

Stop Scan

operation

operation

 

 

 

 

Power Level

Radio transmits

Radio transmits

at high power

at low power

 

 

 

 

 

Radio operates

Radio operates

Squelch

in normal

in tight squelch

 

squelch

 

 

 

 

 

Repeater/

Radio DOES

Radio uses the

NOT use the

Talkaround

repeater

repeater

 

 

 

 

 

VOX

VOX enabled

VOX disabled

 

 

 

†Available for 4W and 5W models only.

Starting or Stopping Scan

1.Press the preprogrammed Scan button to start scan. The LED indictor blinks green during scan operation. Or, select a channel that has been preprogrammed for Auto Scan to start scan.

2.Press the Scan button again to stop scan. Or, select a channel that has not been preprogrammed for Auto Scan to stop scan.

Deleting a Nuisance Channel

1.With radio on a Nuisance Channel, press and hold the preprogrammed Nuisance Delete button until you hear a tone.

2.Release the Nuisance Delete button.

Image 42
Contents CP150/CP200 Page Contents Radio Calls AccessoriesComputer Software Copyrights ScanSafety and Warranty Charging BatteriesLimited Warranty MotorolaII. General Provisions Safety and Warranty What this Warranty does not Cover VII. Governing LAW Warranty Signaling Features FeaturesRadio Wide Features IntroductionIntroduction Radio Overview Parts of the RadioCP150/CP200 Models Channel Selector Knob On/Off/Volume KnobLED Indicator Push-to-Talk PTT ButtonProgrammable Buttons Feature Short Press/Long Press Hold Down Button Indicator Tones Audio Indicators for Programmable ButtonsImproved Audio Features CompandingCharging Your Battery Getting StartedWall Charger Desktop Chargers Rapid ChargerSlow Charger Accessory Information Removing the BatteryAttaching the Battery Attaching the Antenna Removing the Antenna Attaching the Belt Clip Removing the Belt Clip Adjusting the Volume Turning the Radio on or OFFSelecting a Radio Channel Receiving MonitoringTransmitting VOX Operation ENABLE/DISABLE Headset SidetoneConnecting a VOX Headset Enabling or Disabling VOXRepeater or Talkaround Mode Setting Tight or Normal SquelchNon-VOX Headset with In-Line PTT Setting the Power Level Available for 4W and 5W models onlyGetting Started Radio Calls Receiving a Selective CallReceiving a Call Alert Radio Calls Scan Deleting a Nuisance Channel Restoring a Channel to the Scan ListPrioritizing a Scan List Member Scan Chargers AccessoriesCarry Accessories BatteriesHeadsets Surveillance AccessoriesRemote Speaker Microphones EAR Microphone SystemsAntennas MiscellaneousCP150 /CP200 Quick Reference Card Turning Off the Radio Page 6880309N60