Icom IC-M32 instruction manual Battery pack, To remove the battery pack

Page 9

SUPPLIED ACCESSORIES AND ATTACHMENTS 2

ïBattery pack

To remove the battery pack:

Turn the screw counterclockwise, then pull the battery pack in the direction of the arrow as shown below.

To attach the battery pack:

Insert the battery pack in the IC-M32 completely, then turn the screw clockwise.

NEVER remove or insert the battery pack when the trans- ceiver is wet or soiled. This may result water or dust get- ting into the transceiver/battery pack and may result in the transceiver being damaged.

Screw position

when removing battery

LO	CK
LO
OPEN

Screw position

when attaching battery

LO	CK
OPEN

NOTE: When removing or attaching the battery pack, use

a coin or ﬂat-blade screwdriver to loosen or tighten the bot- 2 tom screw.

CAUTION!:

When attaching or removing a battery pack, make sure the rubber seal is set in the groove of the battery pack cor- rectly. If the seal is not neatly in the groove it may be dam- aged when attaching the battery pack.

If the seal is damaged, waterprooﬁng is not guaranteed.

NOTE:

When attaching a battery pack, make sure dust or else does not adhere to the rubber seal. If dust or else is on the seal when attaching a battery pack, the water resistant may be reduced.

Make sure both the rubber seal (purple) is set to the groove correctly and dust or else does not adhere to it.

Correct position	Incorrect position
	Rubber seal
	Groove
Battery pack	Battery pack

3

Image 9

Contents IM32 Safety Training Information Case of Emergency Clean the Transceiver Thoroughly with FreshWord Definition Rwarning ForewordPrecaution Table of Contents Priorities Operating RulesPrivacy Radio licensesSupplied Accessories and Attachments Supplied accessoriesAttachments To remove the battery pack Battery packFront, top and side panels Panel DescriptionPanel Description 0PTT Switch PTT0SUB Channel Readout Function display2VOLUME Level Indicator 1SQUELCH Level Indicator3VOLUME Level Adjusting Indicator 4SQUELCH Level Adjusting IndicatorChannel selection Basic OperationChannel Channel 9 Call channelWeather channels S.A., International and Canadian channelsAdjusting the squelch level Adjusting the volume levelReceiving and transmitting Call channel programming Lock function Automatic backlightingMonitor function Scan types Scan OperationPriority Scan Normal ScanStarting a scan Setting tag channelsDescription DUALWATCH/TRI-WATCHOperation DUALWATCH/TRI-WATCH SimulationSET Mode SET mode programmingSET mode operation Beep tone function bP SET mode itemsWeather alert function AL Priority scan function PrMonitor switch action Sq Scan resume timer StAuto scan function AS Dual/Tri-watch function dtPower save function PS Automatic backlighting bLLCD contrast selection LC Self check function SC Battery voltage indicator btSET Mode List Battery charging Battery ChargingBattery caution Recycling information U.S.A. onlyCharging connections Optional battery caseAD-103 installation Optional battery chargersRapid charging with the BC-121N+AD-103 Rapid charging with the BC-119N+AD-103MB-87 contents Swivel Belt ClipTo attach To detach Problem Possible Cause Solution TroubleshootingUSA INT VHF Marine Channel ListSpecifications General ReceiverTransmitter Options Battery Case and PackPage Kamiminami, Hirano-ku, Osaka 547-0003, Japan