FLIP/RELEASE PANEL | SWITCHING ON/OFF |
➮Press the 
button 1.
This unlatches the flip/release panel.
➮First pull the flip/release panel straight and then to the left out of the unit.
●After removing the flip/release pan- el, the unit switches itself off.
●All the current settings are saved.
●If there is a CD in the unit, it re- mains there.
Attaching the flip/release panel
➮Slide the flip/release panel from left to right into the unit guide.
➮Press the left side of the panel into the unit until it slots into place.
Note:
●Do not press against the display while attaching the flip/release pan- el.
If the device was still switched on when you removed the control panel, it will automatically switch on again with the last settings activated (i.e. radio, CD, CD changer/Compact Drive MP3 or AUX) when the panel is replaced.
Switching on/off
There are various ways of switching the car radio on and off, as described be- low.
Switching on/off using the ignition
If the car radio is correctly connected to the ignition and has not been switched off using the button 3, it is switched on/off simultaneously with the ignition.
You can also switch on your car radio when the vehicle ignition is off.
➮To do so, press the button 3.
Note:
To protect the vehicle battery, the unit switches off automatically after one hour.
Switching on/off using the flip/ release panel
➮Remove the flip/release panel. The unit switches itself off.
➮Replace the flip/release panel once more.
The car radio is switched on. The last settings (radio, CD, CD changer/Com- pact Drive MP3 or AUX) are activated.
Switching on/off using the button 3
➮To switch the unit on, press the but- ton 3.
➮To switch the unit off, hold the but- ton 3 down for more than two seconds.
The car radio is now switched off.
42