Cobra Electronics 75 WX ST Setting the Squelch, Setting Squelch, Soundtrackertm

OPERATION

SETTING THE SQUELCH

18

OPERATION

SETTING THE SQUELCH

19

SETTING THE

SQUELCH

1.Turn CB on by turning the volume control clockwise. Adjust the volume to a comfortable level.

2.Before setting the squelch control on your radio, you must select a channel that is not in use.

3.Turn on SoundTracker.

To achieve the Desired

Squelch Setting (DSS):

4.Think of your Squelch Control as a gate for incoming signals. If you

turn the Squelch Control fully clockwise, it raises the “squelch gate” so high that no signals get through.

SOUNDTRACKERTM

5. If you turn the squelch
control fully counter-
clockwise, it lowers the
“squelch gate” so low
that everything gets
through
- noise,	SOUNDTRACKERTM
weak
signals
and
strong
signals.

6.To set the “squelch gate”

to the DSS-Desired
Squelch Setting, turn the
squelch control
counterclockwise until
you hear noise. Then turn
the squelch control back
clockwise	SOUNDTRACKERTM
just until
the noise
stops.
Now only
strong
signals
get through.

The Desired Squelch Setting, (DSS) only allows actual transmissions to come through. This effectively blocks out unwanted noise.