La Crosse Technology WS-7032U Mounting with Adhesive Tape, II. the Weather Station

Page 12

location. Through the three screw holes of the bracket, mark the mounting surface with a pencil.

3.Where marked, start the screw holes into the mounting surface.

4.Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket.

5.Snap the Remote Temperature Sensor onto the mounted bracket.

B.MOUNTING WITH ADHESIVE TAPE

1.With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat.

2.Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket.

3.Remove the protective strip from the other side of the tape. Position the Remote Temperature Sensor in the desired location, ensuring that the Weather Temperature Station can receive the signal.

II.THE WEATHER STATION

The Weather Station

12can be mounted on the wall

Image 12
Contents WS-7032U Wireless 433 MHz Miniature Weather Station Table of Contents Inventory of Contents Additional EquipmentDo not Press ANY Buttons for 10 Minutes Quick SET-UP GuidePage Weather Temperature Station LOW-BATTERY & Battery Replacement Features Features Indoor TemperatureII. Weather Forecast Weather Icons II. Outdoor Temperature Weather Tendency ArrowsMounting Mounting with Screws Mounting with Adhesive Tape II. the Weather StationTroubleshooting Wall MountingMaintenance and Care Instructions Page Specifications Temperature measuring rangeWarranty Information Page Support@lacrossetechnology.com