La Crosse Technology WT-5360U III. Program Mode, Programming Sequence, Function Buttons

III.PROGRAM MODE

To enter the Program Mode, hold down the “MODE/MIN” button for 3 seconds, until the time zone flashes at the bottom of the display. The Program Mode Guide is laid out in a manner that allows you to program each function separately, or you can follow the instructions entirely to program the projection alarm. Complete programming is usually done for the initial set-up, and will require you to skip step 1 and 2 of programming sections D-H. To exit the setting mode simply wait approximately 10 seconds for the projection alarm to automatically return to normal operation.

A. PROGRAMMING SEQUENCE

1. Time Zone Setting

2. Manual Time Display

3. Year Setting

4. Calendar Display

5. Time Display in 12/24 hour Mode

6. Indoor Temperature Display

7. Daylight Saving Time On/Off

B.FUNCTION BUTTONS

There are 4 function buttons located on the front of the projection alarm and one on the top. The function buttons are labeled (from left to right): AL/HOUR, light intensity, light direction, MODE/MIN, and SNOOZE (the top bar).

Light Intensity Icon Light Direction Icon

C.TIME ZONE SETTING

1.Hold down the “MODE/MIN” button for 3 seconds; the time zone will appear and begin to flash in the bottom section of the LCD.

2.Use the “MODE/MIN” button to toggle through the time zones and select the appropriate zone. There are 24 time zones to choose from (based relative to the international time standard of GMT (Greenwich Mean Time).

3.Press and release the “SNOOZE” bar to confirm selection and advance to the next section of the set-up.

6