La Crosse Technology WT-5600 ACTIVATING/DEACTIVATING the Alarm, Turning Alarm OFF While Sounding

Page 11
Alarm is Active

2.ACTIVATING/DEACTIVATING THE ALARM

a. After entering the alarm-setting mode, the alarm is activated.

b. To toggle between activating and deactivating the alarm, press the “AL” button briefly. “(((•)))” will be displayed to the left of the time display when the alarm is activated.

c. When the snooze bar is pressed, the display will show the time the alarm is set to below the time display.

3.TURNING ALARM OFF (WHILE SOUNDING)

Note: The alarm will sound for 23 seconds and then increase in volume and speed for another 62 seconds (85 seconds total). If no button is pushed it will shut off and be active for the next day.

a.While the alarm is sounding, press the “SNOOZE” bar to disable the alarm for six minutes.

b.After the “SNOOZE” bar is pressed, the alarm icon will flash in the lower left area of the display.

c.To disable the alarm for 24 hours, press any button other than “SNOOZE” or projection keys.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents WT-5600 Radio Controlled Projection Alarm Table of Contents Features of Projection Alarm Inventory of ContentsQuick SET-UP Guide Detailed SET-UP Guide Battery Installation Programming Sequence Program ModeTime Zone Setting Time Setting Daylight Savings Time Date Setting12/24-HOUR Mode Features & OperationsRADIO-CONTROLLED Time and Date LCD Light Time Alarm Setting the AlarmProjection of Time Turning Alarm OFF While Sounding ACTIVATING/DEACTIVATING the AlarmMaintenance & Care Changing Display Mode DAY, SECONDS, and Alarm TimeSpecifications for WT-5720 TroubleshootingWarranty Information FCC ID OMO-01RX receiver
Top Page Image Contents