La Crosse Technology WT-5600 instruction manual Changing Display Mode DAY, SECONDS, and Alarm Time

Page 12

F.CHANGING DISPLAY MODE (DAY, SECONDS, AND ALARM TIME)

There is three possible display modes to view the date, seconds and alarm time. To change the display (starting at the default of month - date):

1.Press the “MODE/+” button and the display will now show seconds.

2.Press the “MODE/+” button and the display will now show alarm time.

3.Press the “MODE/+” button and the display will now show month – date.

MAINTENANCE & CARE

B.Extreme temperatures, vibrations and shock should be avoided to prevent damage to the units.

C.Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents—they may mark and damage the displays and casings.

D.Do not submerge in water.

E.Immediately remove all low powered batteries to avoid leakage and damage.

F.Replace with new batteries only and of recommended size.

G.Opening the casings invalidates the warranty. Do not try to repair the units. Contact La Crosse Technology for repairs.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents WT-5600 Radio Controlled Projection Alarm Table of Contents Inventory of Contents Features of Projection AlarmQuick SET-UP Guide Detailed SET-UP Guide Battery Installation Program Mode Time Zone SettingProgramming Sequence Time Setting Date Setting 12/24-HOUR ModeFeatures & Operations Daylight Savings TimeRADIO-CONTROLLED Time and Date Time Alarm Setting the Alarm Projection of TimeLCD Light ACTIVATING/DEACTIVATING the Alarm Turning Alarm OFF While SoundingChanging Display Mode DAY, SECONDS, and Alarm Time Maintenance & CareTroubleshooting Specifications for WT-5720Warranty Information FCC ID OMO-01RX receiver
Top Page Image Contents