La Crosse Technology WS-7220U-IT instruction manual Contents

FCC ID: OMOTX29UTH (transmitter)

RF Exposure mobile:

The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.”

Statement according to FCC part 15.19:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Statement according to FCC part 15.21:

Modifications not expressly approved by this company could void the user’s authority to operate the equipment.

Statement according to FCC part 15.105:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help

WS-7220U-IT

915MHz

Wireless Weather Station

Instruction Manual

Contents

LanguagePage

English2

French24

Spanish48

TABLE OF CONTENTS

Topic	Page
Introduction	3
Inventory of Contents	4
Quick Set Up	4
Detailed Set Up	6
Battery Installation	6
12 or 24 Hour Time Display	8
Time Setting	9
Features	10
Minimum & Maximum Temperature
and Humidity	10
Resetting Minimum & Maximum
Temperature and Humidity	10
Adding Additional Thermo-Hygro
Sensors	11
Viewing & Operating with Multiple
Thermo-Hygro Sensors	13
Mounting	13
Troubleshooting	17
Maintenance & Care Instructions	18
Specifications	18
Warranty Information	19

GB P.2

This product offers:

I N S T A N T

TRANSMISSION

is the state-of-the- art new wireless transmission technology, exclusively

designed and developed by LA CROSSE

TECHNOLOGY. INSTANT TRANSMISSION

offers you can an immediate update (every 4 seconds!) of all your outdoor data measured from the transmitters: follow your climatic variations in real-time!

12 or 24 Hour Time Display

Indoor	Outdoor
	Temperature
Temperature
	(˚F or ˚C)
(˚F or ˚C)
Connection w/	Outdoor
	Humidity
Sensor Icon	(%RH)
Low Battery
Indicator	Minimum/
	Maximum &
	Plus Button
Set/Channel
Button
Figure 1	P.3 GB

Wireless

Thermo-hygro

Sensor

TX29UD-TH-IT

Mounting
Bracket	Figure 2

INVENTORY OF CONTENTS

1.Wireless Weather Station (Figure 1)

2.Wireless Thermo-Hygro Sensor (TX29UD-TH- IT) and mounting bracket. (Figure 2)

3.3 each, 1/2" Philips screws.

4.One strip of double sided adhesive tape.

5.Instruction Manual and Warranty Card.

ADDITIONAL EQUIPMENT (not included)

1.1 Philips screwdriver.

2.2 Fresh “AA” 1.5V Alkaline Batteries.

3.2 Fresh “AAA” 1.5V Alkaline Batteries.

QUICK SETUP

Hint: Use good quality Alkaline Batteries; avoid rechargeable batteries.

GB P.4

1.Have the Wireless Weather Station and thermo-hygro sensor 3 to 5 feet apart.

2.Batteries should be out of both units for 10 minutes.

3.Place the batteries into the thermo-hygro sensor first and next into the Wireless Weather Station.

4.DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.

In this time the Wireless Weather Station and the thermo-hygro sensor will begin to communicate with each other, and the display will show both the indoor temperature and an outdoor temperature. If the Wireless Weather Station does not display both temperatures after the 15 minutes, please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 15 minutes you can place your thermo-hygro sensor outdoors, and set your time.

The thermo-hygro sensor should be placed in a dry, shaded area (ex: under the eve of a roof). The thermo-hygro sensor has a range of 330 feet. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have up to 20 feet of resistance and an interior wall will have up to 10 feet of resistance. Your distance plus resistance should not exceed 330 feet in a straight line.

NOTE: Fog and mist will not harm your thermo-

P.5 GB