Philips AZ1055 manual Power Supply, Batteries, Mains

Page 2

POWER SUPPLY

Batteries

For the set (optional)

Open the battery compartment of the set and insert 6 batteries, type R20, UM-1or D-cells (preferably alkaline).

For the remote control (optional)

Open the battery compartment of the remote control and insert 2 batteries, type R03, UM-4or AAA-cells (preferably alkaline).

Remove batteries if they are flat or if the set is not going to be used for a long time.

Batteries contain chemical substances, so they should be disposed of properly.

Mains

1Check whether the mains voltage as shown on the type plate

corresponds to your local mains voltage. If it does not, consult

A

your dealer or service organisation. The type plate is located

 

on the bottom of the set.

2 If the set is equipped with a VOLTAGE selector A, set this selector to the local mains voltage.

3Connect the mains cable to the AC MAINS socket and the wall socket. This switches on the mains supply. The mains cable is inside the battery compartment.

The battery supply will be switched off when the set is connected to the mains. To change over to battery supply, pull out the plug from the unit’s AC MAINS socket.

To disconnect the set from the mains completely, remove the mains plug from the wall socket.

For users in the U.K.: please follow the instructions on page 2.

English

5

Page 1 Page 3
Image 2
Page 1 Page 3
Contents
Back of the set Remote controlEnhances the bass PlaybackMains Power SupplyBatteries Radio tuning to radio stations Switching the set on and offAdjusting volume and sound Basic FunctionsCD Player Playing a CDSearch backward and forward ¤ CD Mode Shuffle and RepeatChosen mode Selecting another trackErasing the program CD Mode Programming track numbersPlaying the program Press 2 to play the programGeneral information on recording Protecting tapes from accidental erasureRecording from the CD player CD synchro start Set the Power slider to CDCassette Recorder Recording from the radioGeneral Information General maintenanceTape deck maintenance CD player and CD handlingTroubleshooting Problem Possible cause SolutionDe la lecture CD Réglage du volume’enregistrement ou la lecture ¤ .........................saut et recherche en avantSecteur AlimentationPiles Mise en marche et arrêt Réglage du volume et du sonFonctions DE Base Radio réglage des stationsPour lire un CD Réglez le commutateur coulissant Power sur CDLecteur DE CD Sélection d’un autre morceau CD Mode Shuffle et RepeatRecherche en arrière et en avant ¤ Recherche d’un passage en cours de lecture CDEffacer la programmation CD Mode programmation des morceauxLecture programmée Appuyez 2 sur pour démarrer la lecture du programmeGénéralités sur l’enregistrement Platine CassetteLecture d’une cassette Protection des bandes contre un effacement involontairePour mettre fin à l’enregistrement, appuyez sur OPEN·STOP Enregistrement depuis le lecteur de CD CD synchro startEnregistrement à partir de la radio Entretien des platines cassettes Informations GénéralesEntretien général Lecteur de CD et manipulation des CDProblème Cause possible Solution Recherche DE Pannes