Philips AX5003/10 manual General Information, Environmental information, CD-player and CD handling

Page 7

POWER SUPPLY / GENERAL INFORMATION

English

Mains adapter (supplied or optionally available)

 

Use only the AY 3170 adapter (4.5 V/300 mA direct

 

current, positive pole to the centre pin). Any other

 

product may damage the player.

 

 

 

 

1 Make sure that the adapter’s voltage corresponds to

4.5V DC

 

 

 

the local voltage.

 

 

2 Connect the adapter to the 4.5V DC socket of the

 

 

player and to the wall socket.

 

 

Note: Always disconnect the adapter when you are not using it.

 

Belt Clip (not on all versions)

 

 

1 To attach the belt clip to the CD-player, position the

 

 

shaped grip (found on the back of the belt clip) so that

BELT CLIP

 

 

 

it fits into the belt clip hole of the CD-player.

 

2Turn the clip to LOCK as indicated on the set.

3To detach, gently lift the belt clip and turn

to RELEASE as indicated on the set.

LOCK

 

LIFT

 

RELEASE

Environmental information

All redundant packing material has been omitted. We have done our utmost to make the packaging easily separable into two mono materials: cardboard (box) and polyethylene (bags, protective foam sheet).

Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packing materials, exhausted batteries and old equipment.

GENERAL INFORMATION

CD-player and CD handling

• Do not touch the lens Aof the CD-player.

Do not expose the set, batteries or CDs to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight).

• You can clean the CD-player with a soft, slightly dampened, lint-free cloth. Do not use any cleaning agents as they may have a corrosive effect.

To clean the CD, wipe it in a straight line from the centre towards the edge using a soft, lint-free cloth. A cleaning agent may damage the disc! Never write on a CD or attach a sticker to it.

The lens may cloud over when the set is moved suddenly from cold to warm surroundings. Playing a CD is not possible then. Leave the CD-player in a warm environment until the moisture has evaporated.

Active mobile phones in the vicinity of the CD-player may cause malfunctions.

Avoid dropping the set as this may cause damage.

Headphones HE 545

• Connect the supplied headphones to the LINE OUT/p socket of the player.

Note: LINE OUT/p can also be used for connecting the player to your HiFi system (with a signal lead) or to your car radio (with a cassette adapter or signal lead). In both cases, the volume of the player must be set to position 8.

Use your head when using headphones

Hearing safety: Do not play your headphones at a high volume. Hearing experts advise that continuous use at high volume can permanently damage your hearing.

Traffic safety: Do not use headphones while driving a vehicle. It may create a hazard and it is illegal in many countries. Even if your headphones are an open-air type designed to let you hear outside sounds, do not turn up the volume so high that you cannot hear what is going on around you.

English

10

11

Image 7
Contents AX5002 AX5003 AX5004 México Page Español GuaranteesEnglish FrançaisCONTROLS, refer to the illustration on Remote control not on all versionsPower Supply CD-player and CD handling Headphones HEGeneral Information Environmental informationPlayback information Volume and bassCD Play Playing a CDSelecting a track and searching FeaturesProgramming track numbers Hold locking all buttons Selecting different playing possibilities ModeResume continuing from where you have stopped Resume and HoldPouch AY 3266 supplied or optionally available IN-CAR ConnectionIn-car use connections supplied or optionally available Problem Possible cause Solution Troubleshooting