3.Connect the accessory AC power cord into the socket in the back of this unit. Then insert the cord plugs into an AC outlet. (Do not connect the power cord to a switched AC outlet of a component if the CompuLink system is used.)
AC POWER CORD
AC power cord
Wall outlet
Installing batteries in the remote control
1. There is a cover for the battery compartment on the back of the remote control. Press the cover down and slide it downward to remove it.
2. Set the two accessory batteries (1.5V, R6P, AA) in the compartment with their polarities in proper positions.
3. Place the cover over the compartment, press it down, and slide it upward so that it firmly covers the compartment.
CAUTION
•Install the batteries with their polarities correctly set.
•Remove the batteries if the remote control is not going to be used for an extended period of time.
•Do not expose the remote control to heat, flame, or direct sunlight.
Replacing the batteries
The service life of batteries normally lasts for about one year though it is dependent on the use of the remote control (it is shortened in low temperatures, too). Replace the batteries any time if the controllable range is reduced (max. range: 7 meters or 23 feet and 30 degrees away from the component).
CAUTION
•Be sure to replace them with the correct batteries (1.5V, R6P, AA).
•Do not use new and old batteries in combination.
3