Basic Operation, Turning the power on

BASIC OPERATION

Turning the power on

Check that the standby indicator on the control panel is lighted. Then press the POWER button either on the control panel or remote control.

STANDBY

POWER

(Remote control)

To turn the power off, press the button again lighting the standby indicator.

NOTE: Keeping the unit in the standby state consumes a mini- mal 6.5 watts. If necessary, unplug the power cord from the wall socket to turn off the power completely.

Loading compact discs

Also see Page 12 for the manner of handling and taking care of compact discs.

1.Press the OPEN/CLOSE button either on the control panel or remote control, opening the disc storage door and exposing carousel slots. “d-OP” is shown in the display.

OPEN/CLOSE

OPEN/

(Remote control)

2.To select a specific slot to load a disc, press the DISC button and turn the DISC/TRACK jog dial, to specify the required slot number, which is shown as “DISC” number on the display.

The carousel rotates to bring the specified slot to the load/unload position, which is in the center of the storage area.

DISC

3. Place the disc in a slot, with its label facing to the left.

DISC/TRACK

TRACK

DISC

DISC EJECT

POWER

SYSTEM

CONTROL

COMPULINK

ENHANCED

CD Label

CAUTION

•Do not put anything except CDs in the storage area.

•8 cm CDs cannot be played back in this unit.

•Be careful not to touch the playback mechanism in the unit.

•Up to 25 discs can be accessed at one time. Trying to insert or remove a disc which is not in the loading area may result in damage to the discs and unit.

•The disc needs to be placed vertically in the storage slot of this component. After taking the disc out of its case, grip the rim of the disc between your thumb and middle finger — be sure to keep the fingers on the narrow, outer- most strip where the surface is solidly bright.

•Do not try to put more than one disc in a single slot. The unit will be damaged.

4.Repeat step 3, or steps 2 and 3, to load discs in the storage. Up to 200 discs can be loaded.

5.When all necessary discs have been loaded, press the OPEN/ CLOSE button to close the storage door. “d-CL” is shown in the display.

CAUTION

Make sure to remove your hand from the storage opening before pressing the OPEN/CLOSE button.

Unloading/changing discs

1.Press the OPEN/CLOSE button to eject a disc in the playback position for unloading or changing.

2.To unload or change discs in other slots, press the DISC button and specify the slot number using the jog dial. The specified disc will be brought to the load/unload position. Then press the DISC EJECT button to raise the disc up.

Repeat this step to unload or change any additional discs.

3.When unloading or changing is completed, press the OPEN/ CLOSE button to close the door. The disc in the load/unload position at this time will then be shifted to the play position.