Cassette tapes
DECK 1/2 | , TAPE | ||
|
| ||
, STOP | VOLUME | ||
, REW/ | DOWN, UP | ||
, | /FF | , DECK2 | |
, DECK1 | |||
| |||
DECK 1 | DECK 2 | ||
PLAY MODE |
| ||
|
| , TAPE | |
|
| , + | |
|
| VOLUME | |
| SKIP |
|
You can use either deck 1 or deck 2 for tape playback.
Use normal position tapes.
High position and metal position tapes can be played, but the unit will not be able to do full justice to the characteristics of these tapes.
1Press [; :, TAPE].
The unit comes on.
If a cassette was loaded, play starts automatically (One touch play).
2Press [c, DECK1] or [c, DECK2] on the main unit and
insert the cassette.
Insert with the side to be played | Front side |
| |
facing towards you and the exposed |
|
tape facing down. |
|
Close the holder by hand. |
|
3Press [; :, TAPE] to start playback.
Every time you press the button: F : ↔ ; R
F :: Forward side is played.
; R: Reverse side is played.
4Adjust the volume with
To stop tape playback
Press [L] (main unit: [L, STOP]).
To select the reverse mode
While TAPE is selected as the source
Press and hold [PLAY MODE].
Every time you press and hold the button:
: One side is played.
: Both sides are played. (forward → reverse) Play stops at the end of the reverse side.
: Both sides are played repeatedly until [L] (main unit: [L, STOP]) is pressed.
To listen to 2 tapes consecutively, load a tape into each deck and select “”. Both tapes will be played repeatedly until [L] (main unit: [L, STOP]) is pressed.
To
Press [g, 4] (rewind) or [f, 3]
To select between loaded decks
Press [PLAY MODE] (main unit: [DECK 1/2]).
Note
• Tape playback is momentarily interrupted if you open the other deck.
• Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.
• Tape slack can get caught up in the mechanism and should be
• taken up before the tape is played.operations Endless tapes can get caught up in the deck’s moving parts if used
incorrectly. Use tapes appropriate to this unit’s
Tape
25
RQT7700