| TROUBLESHOOTING | ||||
|
|
|
|
|
|
| Observe all Safety Guidelines detailed throughout this manual |
| |||
|
|
|
|
| |
|
| STATUS BOARD INDICATORS |
| ||
|
|
|
|
|
|
| SYMPTOM |
|
| CHECK |
|
|
|
| |||
The Air Low LED is lit |
| 1. Make sure there is at least 80 psi connected to the gas connec- | |||
|
|
|
| tion at the back of the machine. |
|
|
|
| 2. | Press the Purge button and set the regulator to 55 psi. The pres- | |
|
|
|
| sure may increase when air stops flowing but this is normal. Do | |
|
|
|
| not reset the pressure while the air is OFF. |
|
|
|
| 3. | Possible faulty Pressure Switch. |
|
|
|
| 4. | Possible faulty Control board. |
|
|
|
| |||
The Safety LED is lit and steady |
| 1. Turn the power OFF and then ON. If torch and consumables are | |||
|
|
|
| properly installed, the Safety LED should turn off. Normal cutting | |
|
|
|
| or gouging can resume. |
|
|
|
| |||
The Thermal LED is lit |
| 1. The machine's thermostat has tripped due to exceeded duty | |||
|
|
|
| cycle limits. Do NOT turn the power off. Allow the machine to | |
|
|
|
| cool for 15 - 30 minutes and the thermostat will reset itself. |
|
|
|
| 2. | The machine's air louvers or fans are obstructed such that air | |
|
|
|
| cannot flow to properly cool the machine. Remove any foreign | |
|
|
|
| material that may block air flow. Blow the machine out with a | |
|
|
|
| clean, dry air stream. |
|
|
|
| 3. | The input voltage is not within ±10% of rated values. |
|
|
|
| 4. | Possible faulty Control board. |
|
|
|
|
|
|
|