MAINTENANCE | ||
|
|
|
REMOVAL, INSTALLATION AND TRIMMING INSTRUCTIONS FOR LINERS
FITTING A SOFT LINER FOR FEEDING ALUMINUM ELECTRODE
INSTALLATION INSTRUCTIONS FOR
DESIGNED FOR FEEDING ALUMINUM WIRE
LINER | GUN LENGTH | WIRE SIZE | LINER COLOR |
|
|
|
|
10 FT. (3.0M) | BLACK | ||
|
|
|
|
15 FT. (4.5M) | BLACK | ||
|
|
|
|
10 FT. (3.0M) | 1/16 (1.6mm) | RED | |
|
|
|
|
15 FT. (4.5M) | 1/16 (1.6mm) | RED | |
|
|
|
|
10 FT. (3.0M) | BLUE | ||
|
|
|
|
15 FT. (4.5M) | BLUE | ||
|
|
|
|
THE VARIATION IN CABLE LENGTHS
MAY PREVENT USE OF THE LINER
IN OTHER GUNS.
1.LAY GUN AND CABLE OUT STRAIGHT ON A FLAT SURFACE, REMOVE THE LINER NUT FROM THE CONNECTOR END OF THE CABLE AND PULL THE OLD LINER OUT OF THE CABLE. REMOVE THE GAS NOZZLE.
2.CHECK THE LINER FOR CORRECT WIRE SIZE AND LENGTH. INSERT THE STEEL END OF THE LINER INTO THE BACK END OF THE GUN UNTIL THE STEEL END OF THE LINER IS FULLY
INSERTED INTO THE DIFFUSER. CHECK THAT THE COILS OF THE LINER CAN BE SEEN
THROUGH THE HOLES IN THE GAS DIFFUSER.
3. MARK THE LINER 3/16" (5mm) FROM THE END OF THE LINER GUIDE. PULL THE LINER PARTIALLY OUT AND CUT OFF THE LINER AT THE MARK. USING A SHARP KNIFE.
4.SCREW THE BRASS LINER NIPPLE ONTO THE LINER AND INSERT THE NIPPLE INTO THE LINER GUIDE.
5.REPLACE THE LINER NUT AND THE GAS NOZZLE.
3/16" (5mm)
LINER GUIDE | LINER GUIDE |
| |
| LINER NUT |
MAGNUM® 450WC & 650WC