Lincoln Electric V200-T manual Operation, Safety Instructions, General Description

Page 13

B-1

OPERATION

B-1

 

 

 

Read and understand this entire section before operating your machine.

SAFETY INSTRUCTIONS

WARNING

ELECTRIC SHOCK can kill.

•Do not touch electrically live parts such as output terminals or internal wiring.

•Insulate yourself from the work and ground.

•Always wear dry insulating gloves.

____________________________________

FUMES AND GASES can be dangerous.

• Keep your head out of fumes.

•Use ventilation or exhaust to remove fumes from breathing zone.

____________________________________

WELDING, CUTTING and

GOUGING SPARKS

can cause fire or explosion

•Keep flammable material away.

•Do not weld, cut or gouge on containers that have held com-

bustibles.

____________________________________

ARC RAYS can burn.

•Wear eye, ear and body protection.

GENERAL DESCRIPTION

The Invertec V200-T is an industrial 200 amp arc welding power source which utilizes single phase input power, to produce constant current output. The welding response of this Invertec has been optimized for stick (SMAW) and TIG (GTAW). The unit is ideal for industrial applications where portability is impor- tant.

OPERATIONAL FEATURES

The Invertec provides continuous total range output current adjustment. Additionally, a “hot start” system has been built into the welding current control, and provides a higher striking current to assist ignition of the arc.

WELDING CAPABILITY

The Invertec V200-T is rated at 200 amps, 28 volts, at 20% duty cycle on a ten minute basis. It is capable of higher duty cycles at lower output currents. It is capa- ble of 120 amps, 25 volts at at 100% duty cycle. If the duty cycle is exceeded, a thermal protector will shut off the output until the machine cools.

LIMITATIONS

The V200-T is not recommended for pipe thawing.

The V200-T should not be powered from the auxiliary power supply of an engine welder. Special protection circuits may operate causing loss of output.

____________________________________

Only qualified personnel should operate this equip- ment. Observe all safety information throughout this manual.

INVERTEC V200-T

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Invertec Safety Depends on YouCalifornia Proposition 65 Warnings SafetyElectric Shock can kill Iii Welding Sparks can cause fire or explosionSûreté Pour Soudage a L’Arc Précautions DE SûretéThank You Table of Contents Technical Specifications V200T TIG InstallationElectric Shock can kill Select Suitable LocationOutput Connections Input Fuse and Supply WireInput Connections Output and GAS Connection for TIG Welding Output Connection for Stick WeldingCylinder could explode if damaged Operation Safety InstructionsGeneral Description Figure B.1 Case Front Controls Controls and SettingsOperation Remote Control Operation Welding in TIG ModeOperating Steps Sept97Set the Welding Process Switch to Stick Welding in Stick ModeRecommended Electrode Amperage Ranges Invertec V200-T Smaw ProcessStep Explanation of 2 Step and 4 Step ModesPulser Function Optional Accessories AccessoriesCable Plugs Safety Precautions MaintenanceInput Filter Capacitor Discharge Procedure Routine MaintenanceHOW to USE Troubleshooting Guide TroubleshootingTroubleshooting Diagrams Parts Invertec V200-T308-A.1 Invertec V-200-T11-4-98 308-CItems Not Shown 308-C.1Invertec V-200-T $700.00 How To Read Shop DrawingsPrecaucion Warnung
Top Page Image Contents