INSTALLATION | ||
|
|
|
Read this entire installation section before you start installation.
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts such as output terminals or inter- nal wiring.
•Insulate yourself from the work and ground.
•Always wear dry insulating gloves.
CONNECTION TO FEEDER WITH READY TO WELD GUN
Connecting a
The
1.Check that the drive roll(s) and feeder guide tubes are appropriate for the electrode size being used.
2.Fully push the brass connector end of the gun cable into the conductor block on the outgoing side of the feeder wire drive. Secure the cable using the hand screw or set screw in the con- ductor block.
3.Insert the round connector of the control cable into the mating connector on the front of the wire feeder.
FIGURE A.1
Connection to Adapted Feeders, Lincoln
The
1.Check that the adapter and feeder outgoing guide, as well as the drive roll, are appropriate for the electrode size being used. On Lincoln feeders, check that the
2.Fully push the brass connector end of the gun cable into the brass adapter on the outgoing side of the feeder wire drive. Secure the cable using the hand screw or set screw in the adapter.
3.Insert the round connector of the control cable into the mating connector on the front of the wire feeder.
CONVERSION OF
Prepare gun and determine correct connector kit
1.Determine which K466 or K613 kit is required for your system using (Tables A.1 and A.2) in the front part of the Installation Section.
2.Remove the insulator, tip holder and gun control cable.
3.Lay gun and cable out straight on a flat surface.
4.Loosen set screw located in the brass cable con- nector at the wire feeder end of the cable using the 5/64 (2.0 mm) Allen wrench. Pull liner out of cable.
5.Remove the brass cable connector from the feeder end of the gun using the wrench provided.
6.Install the new connector kit using the appropri- ate procedure which follows.
K466-3/K613-3 Installation (For Miller feeders)
1.Remove brass cable connector (see Figure A.2) from the kit and screw it on to the feeder end of the gun cable. Tighten the connection with the wrench provided.
2.Attach the round connector of the gun control cable provided to the trigger connector on the front of the Miller feeder.