Lincoln Electric K126-12, K126-11, K126-10 manual K466-4 Installation For Hobart feeders i.e

A-5 INSTALLATION A-5

K466-4 Installation (For Hobart feeders; i.e. 27...)

1.Remove brass cable connector (see Figure A.2) from the K466-4 kit and screw it on to the feeder end of the gun cable. Tighten the connector with the wrench provided.

2.Attach the phone plug connector of the gun con- trol cable provided to the trigger connector on the front of the Hobart feeder.

K466-5 Installation (For L-Tec feeders equipped with an L-Tec feeder connector assembly, MIG 35, MIG 31A, 225...)

1.Remove brass cable connector (see Figure A.2) from the K466-5 kit and screw it onto the feeder end of the gun cable. Tighten the connection with the wrench provided.

2.For L-Tec machines that require trigger lead connections to be made at a terminal strip locat- ed within the machine (L-Tec 225), a gun con- trol cable with forked terminals is provided. Connect the terminated leads to the terminal strip. For a machine that requires a twist-lock gun control cable connection, continue to use the L-Tec gun control cable provided with the L- Tec wire feeder connector assembly. Connect the twist-lock plug to the proper receptacle on the machine.

K466-6, K466-7, and K466-9 Installation

(Wirematic, Hobart Series 2000 Feeders, SP100T

Type and Power MIG)

1.Remove brass cable connector (see Figure A.2) from the connector kit and screw it onto the feeder end of the gun cable. Tighten the connection with the wrench provided.

2.Attach the gun control cable provided to the trigger connector on the wire feeder.

K613-2, K613-7 Installation (Tweco #5 compatible feeders)

1.Remove brass cable connector from the kit and screw it onto the feeder end of the gun cable. Tighten the connection with the wrench provid- ed.

2.For K613-7, attach the round connector of the gun control cable provided to the trigger con- nector on the front of the Lincoln feeder.

K613-6 Installation (Lincoln Feeders, 3/32” diam- eter wire)

1.Remove brass cable connector and insulation tube from the kit. Slide the insulation tube onto the connector from the threaded end and screw it onto the feeder end of the gun cable. Tighten the connection with the wrench provided.

		FIGURE A.2
	INSULATION TUBE
	(K466-1 ONLY)		GUN HANDLE
BRASS CABLE				SHIELD CLAMPING SCREWS
	FEEDER END
CONNECTOR
	CABLE HANDLE
				GUN TUBE
	MOLDED GAS	CABLE
	PLUG
SET SCREW				TIP
LINER ASSEMBLY (LINER BUSHING TO BE SEATED			TIP HOLDER
TIGHT AGAINST BRASS CABLE CONNECTOR

INSULATOR

K126-10, K126-11 AND K126-12 INNERSHIELD® PRO