Lincoln Electric K126-10, K126-12, K126-11 manual Connection to a Tweco #5 adapted feeder

A-7 INSTALLATION A-7

2.Fully push the brass connector end of the gun cable into the brass adapter on the outgoing side of the feeder wire drive. Secure the cable using the hand screw, set screw, or pin.

3.Insert the control cable plug from the feeder trig- ger circuit into the mating socket on the gun cable feeder end handle. For machines with a twist-lock trigger lead receptacle, if the L-Tec gun control cable does not easily connect with the socket, the gun control cable that came with the K466-5 kit can be used. To do this, cut off the gun control leads as close to the forked ter- minals as possible and skin back the leads 7/16" (11 mm). Remove the twist-lock plug from the L-Tec control cable and connect it to the K466-5 cable. Make sure the outer jacket of the connector is caught within the plug's strain relief.

Connection to Lincoln Wirematic, Power MIG, Hobart Series 2000 Feeders, or SP100T Type Feeders.

Gun cable assemblies which were assembled with a K466-6, K466-7 or K466-9 Connection Kit in the beginning of this Installation Section will connect eas- ily to a feeder.

1.Check that the adapter and feeder outgoing guide, as well as the drive rolls, are appropriate for the electrode size being used.

2.Fully push the brass connector end of the gun cable into the outgoing side of the feeder wire drive. Secure the cable using the hand screw on the wire feeder.

3.Insert the control cable plug from the feeder trig- ger circuit into the mating socket on the gun cable feeder end handle.

Connection to a Tweco #5 adapted feeder.

1.Check that the drive roll(s) and feeder guide tubes are appropriate for the electrode size being used.

2.Fully push the brass connector end of the gun cable into the conductor block on the outgoing side of the feeder wire drive. Secure the cable using the hand screw or set screw in the con- ductor block.

3.Insert the round connector of the control cable into the mating connector on the front of the wire feeder.

Connection to a Lincoln feeder for 3/32” diameter wire

1.Check that the drive roll(s) and feeder guide tubes are appropriate for the electrode size being used.

2.Fully push the brass connector end of the gun cable into the conductor block on the outgoing side of the feeder wire drive. Secure the cable using the hand screw or set screw in the con- ductor block.

3.Insert the round connector of the control cable into the mating connector on the front of the wire feeder.

K126-10, K126-11 AND K126-12 INNERSHIELD® PRO