Spectra Logic 10000 manual Connecting the Scsi Cables and Terminators

Chapter 3. Preparing the Library

Connecting the SCSI Cables and Terminators

Four 68-pin micro-SCSI connectors on the rear panel connect the library to the system SCSI busses. The SCSI connectors are labeled SCSI Port 1 (IN and OUT) and SCSI Port 2 (IN and OUT).

Note: Make sure to review The SCSI Bus on page 118 before connecting your library.

To attach SCSI connections between the library and the host:

1.Attach the SCSI cable to the library (a dual bus library requires two SCSI cables).

2.Terminate the SCSI bus with a SCSI terminator (or two SCSI terminators if you are configuring the library as a dual bus library).

Note: All SCSI busses must be terminated at the output of the final SCSI device on the bus (see SCSI Cables and Terminators on page 119).

39