Spectra Logic 10000 manual Resetting Drive Emulation

Chapter 5. Operating the Library

Resetting Drive Emulation

1.Go to the main Configuration screen and touch More > More > More to get to the Emulate 1/2 and Emulate 3/4 buttons.

2.Confirm that the values are set the same as recorded at the beginning of this procedure.

3.Press Save Parms to save the current settings, then press No to avoid restarting the system.

4.Confirm that the emulation settings are set correctly by going back to the main screen and selecting each drive button.

5.On the second Drive Info screen (press a drive button, then More), check the Switch Override setting. This setting should match the settings of the Emulate buttons.

6.Also on the Drive Info screen, verify the SCSI Bus Mode setting; this should match what you have set in the Configuration screen.

Note: There is one exception. Emulation settings for 16, STK 9490 will be indicated with the Switch Override Value as 0.

Confirm the correct emulation by pressing each drive button and checking that the Manuf setting is STK and the Model setting is 9490.

Caution: The drive firmware tape cannot be used as a data tape, nor can it be copied. Store the tape in a safe location to prevent using it for anything other than firmware upgrades.

72